docs(wiki): shuffle, repeat, start
Signed-off-by: foonerd <157698061+foonerd@users.noreply.github.com>
742e197
docs(wiki): the details sheet, playlist folders, a reopened stream, what holds
Signed-off-by: foonerd <157698061+foonerd@users.noreply.github.com>
ee8f237
docs(wiki): internet radio: playlists, logos, the name card, the ticker, what does not play
Signed-off-by: foonerd <157698061+foonerd@users.noreply.github.com>
3b660ae
docs(wiki): the reservoir, in a paragraph
b47b045
docs(wiki): the network in Configuration; Home mentions it
c7aec4f
docs(wiki): Configuration page; Home and Face brought to what the board does
99cdde6
docs: Home says the face is the player's own, not the companion's pages
d3ec642
docs: the dependency diagram's dotted edges in a form GitHub's Mermaid parses
7a69321
docs: say which rates are measured and which only inferred
3d80ad2
docs: what the board plays and what it does not; 192 kHz greyed in the library
be1b448
docs(face): the player's face, with renders in both orientations and the five themes; hero on Home
2696d7c
docs: wiring a Pi-HAT DAC to the panel; Boards, the targets by role; pages follow the firmware
Audio out gains the bench form of the DAC connection: a figure and a
table of the three I2S wires, ground and the two I2C lines from the
HAT's 40-pin header to J8, J6 and J5, with the power rule (the HAT on
its own supply; J8 pin 2 is USB VBUS without a diode) and what the
firmware logs at boot. Every pin reference on the page now matches the
firmware that plays: BCLK GPIO 2, LRCLK GPIO 3, data GPIO 11, GPIO 12
spare, where the page had proposed GPIO 3, 12 and 11 before a wire was
connected. The standing table, the firmware section and the bench list
say what is proven (tone, FLAC at 44.1 and 96 kHz, MP3, the sink's
volume) and what is not (tier 1 on J5, 32-bit slots, I2S slave).
Boards is new: the ESP32 touch panels recorded as targets, read from
the makers' pages on 19 October 2026, one table per role, with what a
board must have to be a target and how to read a question mark.
Hardware and Home follow: the stereo route is built and plays, the
firmware crate exists, and the companion's crates come by tag where one
exists.
Signed-off-by: foonerd <157698061+foonerd@users.noreply.github.com>
8c21f57
docs(audio-out): powering a DAC board from the panel: the inline 5 V filter, with schematic
04ac493
docs(audio): DAC2 HD parts and addresses from the kernel overlay; sources say which page gave what; pin 36's two jobs
a4f5fc1
docs: Hardware counts the expander lines; Home lists the register's families
aa838a6
docs(audio): corrections from review: HiFiBerry rows, tiers, expander lines, Pi header rails, TAD5242 headphones, WM8804 outputs, cable note, ES9020 status; J8 5 V settled on paper
1d20f4e
docs(audio): Audio out as an options register against the panel's constraints; Hardware and Home follow
No part chosen. Pi DAC HATs, bare I2S modules, TI (PCM5102A, PCM5122,
TAD5242/5212), ESS (9023P, 9018K2M, 9028Q2M, 9038Q2M, 9039Q2M), a speaker
amplifier (MAX98357A), digital out (WM8804 class) and Hymnal, each with
clock, control, volume, output, tier and the maker's lifecycle word as
read today. Carrier board shaped as a Pi header plus a module header on
the same three lines; the PCM5102A kept as the worked example of a
soldered part. Bench list extended for tier-1 boards and the slave role.
de3d924
docs(home): the standing line and the crate map after the audio contracts and the host distribution
3058a3b
docs(home): the standing line, host first
01b14fe
docs: Home and Hardware, the sidebar and the footer
247132d