Not able to see Wifi Module

[abhijeetshukla007]

Hi There,
I am new to arduino community was trying the same, I have followed the same steps but I am not able to see ESP wifi in wifi list, Please help.

Attached success message

[tickietackie]

Did you find a solution for this issue?
I'm getting exactly the same empty response.

[thefireflyer]

same here

[planktonfun]

got the same problem, got it working, the diagram is wrong interchange RX to TX and TX to RX and remove the 10k resistor

to test the bare minimum use code:

SoftwareSerial esp8266(2, 3); // interchange RX to TX, TX to RX

void setup()
{
  Serial.begin(9600); // serial port used for debugging
  esp8266.begin(115200);  // your ESP's baud rate might be different
  
  Serial.println("type something to direct to the device"); // turn on Both NL&CR in serial monitor
}

void loop()
{
  if(esp8266.available() > 0)  // check if the ESP is sending a message
  {
    Serial.println(esp8266.readString());
    delay(100);
  }

  if(Serial.available()  > 0)
  {
    // send to the esp8266
    esp8266.println(Serial.readString()); 
    delay(100);
  }
 }

then send "AT" it should reply "OK"