Skip to content

A short, simple tutorial for using Light Dependent Resistors with RNBO on the Raspberry Pi

License

Notifications You must be signed in to change notification settings

lysdexic-audio/RNBO-RPi-LDR

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

3 Commits
 
 
 
 
 
 
 
 

Repository files navigation

RNBO-RPi-LDR

In this article we'll cover how to use some simple sensors with RNBO on the Raspberry Pi target.

⚙️ Before attempting this tutorial, make sure you're already familiar with the basics of exporting your RNBO patchers to the RPi and that your audio interface is working correctly with it.

Things you'll need:

  • 1 x 1uf capacitor
  • 1 x Light Dependent Resistor (aka Photoresistor)
  • Breadboard
  • Hook up wires

We'll start by exporting the following patcher to the Raspberry Pi target:​

To control the cutoff parameter of this patcher with an LDR, we'll write a quick python script on the Raspberry Pi to use alongside the rnbo runner - ssh in, or connect up a keyboard. We'll use a library that should already be on your RPi image called gpiozero and another for communicating with the runner via OSC. You can use any OSC library you like, this example will use pyliblo3.

To install pyliblo3 run the following two commands from the terminal on your RPi.

sudo apt install liblo-dev
pip install pyliblo3

Now sudo poweroff the RPi, and disconnect the power. Let's create our circuit:

  1. 3.3v (red) from the RPi connects to one side of the LDR
  2. GND (black) from the RPi connects to the ground bus rail
  3. The 1uf capacitor connects the shorter leg to the ground bus rail, the longer leg connects to the terminal strip inline with the LDR
  4. RPi GPIO 4 (blue) connects in between the LDR and the capacitor

The sensor.value from the LDR is already normalized - so we can use this directly to control the cutoff parameter via the normalized osc address. If you take a look in the patcher, you will see there is some logarithmic scaling of this via @fromnormalized which makes it feel more natural.

Switch the Pi back on and at the terminal run the script:

python RNBO-RPi-LDR.py

Now grab a flashlight and voila! You should be opening up and closing the filter with your light source.

About

A short, simple tutorial for using Light Dependent Resistors with RNBO on the Raspberry Pi

Topics

Resources

License

Stars

Watchers

Forks

Languages