Repository navigation
Replies: 4 comments 3 replies
|
Hi @Grammid, thank you for volunteering!
|
|
@Grammid R3002 and R61 - I stand corrected, they are indeed connected in parallel. My mistake. I'll remove R3002 and leave R61 shared on the main PCB. |
|
The side sensor is now placed and routed in KiCad 10 (9 parts, 2 layers, GND pours on both sides), and DRC is clean. I’ve opened a draft pull request to oomwoo-pcb with screenshots of both copper layers and the 3D view: here. The 24 × 15 mm outline and the M2 holes (19 mm apart) are placeholders, so I'll adjust them once the holder is ready this month and then mark the PR ready. One thing I noticed in the library: the IRM-H638T footprint's courtyard (±2.0 × ±2.5 mm) only covers the body. Its pads reach ±3.4 mm, about 1.4 mm outside it on each side, so DRC won't flag parts placed right against them. Enclosing the pads plus 0.25 mm would give ±3.65 × ±2.75 mm. The footprint is also used on the charging dock and the rear IR board.
|





Uh oh!
There was an error while loading. Please reload this page.
Hi! I'm David, a robotics bachelor student and I'd like to contribute PCB layouts for the v1 small boards in oomwoo-pcb.
I'm starting with:
Later I'd be happy to take on more of the small boards (cliff, rear IR or Hall sensor) if nobody else has them.
A few questions before I go too far:
I'll post placement screenshots here before routing. Thanks.
Regards, Dave.
All reactions