can't get path

[NPU-yuhang]

Hi, thanks for your project. I have compiled it successfully, but when I run the launch file and clicked "start planer" in the rviz, the planner can't get an available path. The outputs from terminal are as follow:

[Zheng-CW]

Hello, have you resolved this issue? Currently, my running results also indicate this issue. Can you give me some suggestions？

[MihirDharmadhikari]

Hello,

In the above issue, it seems like the tree is not being built properly. Can you visualize the motion primitives tree and send a screenshot? In addition, can you also check if the voxblox map is created properly? If it is not that might be causing the issue.

Best regards,
Mihir

[Zheng-CW]

Hello, I went to run the MBplanner algorithm again and found that the error is not the same as before, because it was the same error in a certain algorithm before, but it has not been resolved. Sorry.

And now when I run the MBplanner algorithm, it always report errors such as planner is waiting for odometry and waiting for odometry! Then I used the rostopic list to see /velodyne_ Points, using rostopic echo /velodyne_points After checking the points, it was found that there was no data displayed. It should be a problem with the node's publishing and subscription data. I'm not very good at handling it later on. It seems that several algorithms have been adjusted to solve this problem. May I ask how you can solve this problem? I look forward to your valuable suggestions!

I try my best to solves these problems but it is range out of my abilities, and pleases forgive my poor English!