Skip to content

Design Notes

Matt Pare edited this page Dec 29, 2016 · 28 revisions

This design, and notes, borrow heavily from the wonderful words and wisdom presented by Paul Horowitz and Winfield Hill in "The Art of Electronics (3 Ed.)".

Unregulated Power Supply

Power Supply Filtering

The rectified outputs of D1 (with respect to GND) contain significant ripple that must be smoothed out by large aluminum electrolytic capacitors before reaching the voltage regulator stage of the power supply. Capacitors should be chosen large enough to provide acceptably low ripple voltage but with high enough voltage rating sufficient to handle the worst case combination of no load on the transformer secondary and high line voltage (15%).

Under the following comments, the value of the capacitors (C) required for a specified ripple voltage (V) under full load current (I) can be conservatively approximated as C = I / (f * V). In short, the greater the load current the larger the capacitors need to be to maintain the specified ripple current.

  1. Ripple frequency of a full-wave rectified 60 Hz line main is 120 Hz (f) (60 Hz for half-wave).
  2. Ripple is small compared to output voltage of rectifier D1. Assume 1 Volt peak-to-peak is the specified ripple requirement.
  3. The downstream voltage regulators appear as constant-current load. For this design, 2 A load current selected even though larger than maximum current supply of the regulator.
  4. The discharge of the capacitor is modeled as a ramp.
C = (2 A) / (120 Hz * 1 Vpp)
C = ~16,667 uF

Positive Voltage Regulator

Bypass Capacitors

It is recommended that the regulator input be bypassed with capacitor if the regulator load capacitance is large. An input bypass capacitor should be selected to provide good high frequency characteristics to insure stable operation under all load conditions. A 0.33 uF or larger tantalum, mylar or other capacitor having low internal impedance at high frequencies should be chosen. The bypass capacitor should be mounted with the shortest possible leads directly across the regulator input terminals.2

No output bypass capacitor is needed for stability but it does improve transient response.1

Reverse Polarity Protection

In addition to protecting against reverse polarity connection caused by operator error or equipment failure, the diodes protect against latch-up problems.2

References

  1. Horowitz, Paul, and Winfield Hill. 2015. The art of electronics. New York: Cambridge University Press.
  2. : L7800 Datasheet

Clone this wiki locally