Skip to content

Home

Jump to bottom
ploopyco edited this page Feb 8, 2023 · 1 revision

So, you want to build a set of Ploopy Headphones, eh? Or, maybe you want to replace some broken parts. Maybe you want to reprogram it. Or maybe you just want to know how it all works. No matter the motivation, this is the place to learn.

Bought a kit and itching to get it built? --> Get started by going to Part 1: Introduction.

Looking to purchase a kit with everything you need to build a set of Ploopy Headphones? --> Check out the Ploopy store.

Building a set of Ploopy Headphones from scratch? --> Get started by going to Appendix A: Printed circuit boards.

Copyright (C) 2023 Ploopy Corporation. Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.3 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts. A copy of the license is included in the section entitled "GNU Free Documentation License".

Home

Official Ploopy Headphones Kit Assembly, Revision A

Part 1: Introduction

Part 2: Drivers

Part 3: Ear Cups

Part 4: Headband

Part 5: Amplifier, Cables and Conclusion

Appendices

Appendix A: Printed circuit boards

Appendix B: 3D-printed parts

Appendix C: Firmware Programming

Appendix D: Hardware

Appendix E: Tuning the EQ Profile

Appendix F: Frequency response graph interpretation

Appendix G: Official Ploopy Headphones Fully Assembled Version Instructions, Revision A

Legal

GNU Free Documentation License

Clone this wiki locally