Repository navigation
Replies: 2 comments 1 reply
|
Hi @JuanDYB The D455 camera model does not have a special power requirement. 400 Series cameras typically require up to 2 Watts maximum of power, which most PC USB ports can provide without difficulty. As the 10 m cable works well when inserted after the PC has started up, I would recommend trying a USB hub device if you have not done so already, and plug the camera into the hub instead of directly into the PC's USB port. A hub has its own independent USB controller which is likely to be a different brand that the computer's manufacturer chose to handle the built-in USB ports on the PC. Some USB controller brands may be more reliable with RealSense cameras than others. RealSense users do not usually use USB cables that are based on fiber optics, so there are not past references from users about how the camera would perform on this type of connection. The cameras are useable with a fiber cable though, as shown in the YouTube video below created by the premium quality cable supplier Newnex to demonstrate their RealSense-validated cabling. https://www.youtube.com/watch?v=GLQgR1jT04M An alternative to fiber-based cables would be to use a standard USB cable which has signal-boosting 'active repeater' components built into it to enable a good connection to be maintained over longer distance. Newnex also supply this type of cable. |
|
There is not information about which USB controllers may be less reliable with RealSense cameras than others, unfortunately. And there is no way to know in advance which controller a particular model of computer or USB hub uses. Amazon's own-brand Amazon Basics brand of hub has been highly reliable with RealSense though. Newnex's industrial grade USB cables have EMI shielding. Links to those high quality shielded cable products can be found on their RealSense cable page I linked to above, under the heading 'Industrial-Grade USB Cables for Intel RealSense'. They have both USB A to C and C to C industrial cables. |
Uh oh!
There was an error while loading. Please reload this page.
Hi,
I'm using RealSense D455 and I need more length USB cable to connect it. At least 7.5m.
I have tryed using USB Active cables like the following.
Seems that this type of cables works good with RealSense D455 but I'm having stange problem in some PCs.
If I connect the cable when PC is already started the camera is recognised without problems.
If I start PC with cable connected the camera is not recognised, unplug and plug again solves the problem.
I have tryed with default USB 3.1 cable in same PCs and it works good without problems.
We have also tryed with BIOS configurations like USB power control Changing between 5V_DUAL and 5V with same bad results...
Do you have experience with this type of problems? Any special power requirement that RealSense D455 needs that can cause this type of issues?
With regards,
All reactions