-
Notifications
You must be signed in to change notification settings - Fork 9
DarwinFPV 15A
Petri Mattila edited this page Apr 17, 2024
·
17 revisions
Rotorflight Wiki is replaced by www.rotorflight.org.
The DarwinFPV 15A is an F411 based AIO (all in one) FC that runs on 1S to 3S. It is a 25.5mm (whoop size) mounting pattern.
There are three options for the Darwin 15A.
The Darwin 15A uses the Betaflight Maytek411 custom defaults file. Select the MTKS-MATEKF411 board from the dropdown before flashing rotorflight. After loading "load custom defaults" to configure your hardware. Then from the CLI, load your chosen layout file from above (a, b or c). This will configure your Motors and servos (e.g. Servo pins, motor pins, timers, DMA etc).
- Overview
- Back-up and restore
- Servo Wiring and adapter boards
- Custom Defaults
- Custom defaults remapping spreadsheet
- Receiver Setup
- Gyro & Board Orientation
- Voltage & Current Sensors
- ESC Setup
- Motor Setup
- Servos Setup
- Mixer
- Modes
- RPM Filters
- Filter Setup
- Governor Setup
- Adjustments
- Introduction
- Initial Tuning
- Governor Tuning
- Feed forward Tuning
- Tail Tuning
- Tuning on the Field with Lua Scripts
- Blackbox Logging
- Working with Blackbox Explorer
- K110 with Play F4
- Profile (Bank) switching example
- Using stability modes (6G)
- Adding OSD support for FPV Setups