-
Notifications
You must be signed in to change notification settings - Fork 9
JHEMCU F7 XSD
Petri Mattila edited this page Apr 17, 2024
·
2 revisions
Rotorflight Wiki is replaced by www.rotorflight.org.
The JHEMCU F7 XSD is an F722 based FC that runs on 2S to 6S. It is a 20x20mm mounting pattern.
There are two assignment options for the Foxeer F722 V2. Motorized Tail (MT) and Servo Tail (ST).
Motorized Tail option
Servo Tail option
The JHEF-JHEF7DUAL(ST) and JHEF-JHEF7DUAL(ST) custom defaults are located in the custom defaults repository. Select the JHEF-JHEF7DUAL(MT) or JHEF-JHEF7DUAL(ST) board from the dropdown before flashing rotorflight. After loading "load custom defaults" to configure your hardware (e.g. Servo pins, motor pins, timers, DMA etc).
- Overview
- Back-up and restore
- Servo Wiring and adapter boards
- Custom Defaults
- Custom defaults remapping spreadsheet
- Receiver Setup
- Gyro & Board Orientation
- Voltage & Current Sensors
- ESC Setup
- Motor Setup
- Servos Setup
- Mixer
- Modes
- RPM Filters
- Filter Setup
- Governor Setup
- Adjustments
- Introduction
- Initial Tuning
- Governor Tuning
- Feed forward Tuning
- Tail Tuning
- Tuning on the Field with Lua Scripts
- Blackbox Logging
- Working with Blackbox Explorer
- K110 with Play F4
- Profile (Bank) switching example
- Using stability modes (6G)
- Adding OSD support for FPV Setups