-
Notifications
You must be signed in to change notification settings - Fork 9
Matek f411 wte
Rotorflight Wiki is replaced by www.rotorflight.org.
The Matek F411 WTE is an F411 based FC that runs on 2S to 6S. It is a wing type FC usually used for fixed wing aircraft. It has 2 motor outputs designed for individual external ESC's labeled S1 and S2. This controller has 2 onboard BEC's for onboard power as well as a select-able 5-6V 5A for powering the servos. This makes it ideal for 250 to 450 sized helicopters.
The F411 WTE does not have a Betaflight target (only iNAV). This means you cannot select a target directly from the flashing dropdown. Instead, please choose the processor STM32F411.
After loading the firmware, reconnect and load the Rotorflight config file (MATEKF411WTE.config) following the restore process Back-up and restore.
Motorised tail and Servo tail are on different pins. Wire your board with either a tail Servo (S4) or Tail motor.
MatekF411TE(MT).txt File to be confirmed!!!
MatekF411TE(ST).txt File to be confirmed!!!
Saydals modified the pin headers to 3 rows and connected the top to the receiver and Logger to make connections more compact.
- Overview
- Back-up and restore
- Servo Wiring and adapter boards
- Custom Defaults
- Custom defaults remapping spreadsheet
- Receiver Setup
- Gyro & Board Orientation
- Voltage & Current Sensors
- ESC Setup
- Motor Setup
- Servos Setup
- Mixer
- Modes
- RPM Filters
- Filter Setup
- Governor Setup
- Adjustments
- Introduction
- Initial Tuning
- Governor Tuning
- Feed forward Tuning
- Tail Tuning
- Tuning on the Field with Lua Scripts
- Blackbox Logging
- Working with Blackbox Explorer
- K110 with Play F4
- Profile (Bank) switching example
- Using stability modes (6G)
- Adding OSD support for FPV Setups