Voltage & Current Sensors
Petri Mattila edited this page Apr 17, 2024
·
2 revisions
Rotorflight Wiki is replaced by www.rotorflight.org.
Several features of Rotorflight require the battery voltage to be configured. In particular the governor which will not allow the motor to spool without a valid battery voltage. Select the appropriate sensor (ADC/ESC) and follow the calibration instructions displayed in the popup [Calibration]
Current measurement is not a requirement for rotorflight; however, calibrate the current if you wish to use it for telemetry.
- Overview
- Back-up and restore
- Servo Wiring and adapter boards
- Custom Defaults
- Custom defaults remapping spreadsheet
- Receiver Setup
- Gyro & Board Orientation
- Voltage & Current Sensors
- ESC Setup
- Motor Setup
- Servos Setup
- Mixer
- Modes
- RPM Filters
- Filter Setup
- Governor Setup
- Adjustments
- Introduction
- Initial Tuning
- Governor Tuning
- Feed forward Tuning
- Tail Tuning
- Tuning on the Field with Lua Scripts
- Blackbox Logging
- Working with Blackbox Explorer
- K110 with Play F4
- Profile (Bank) switching example
- Using stability modes (6G)
- Adding OSD support for FPV Setups