Collecting debug information

p2p debug command helps to understand your setup and it's better to include output of this command in an issue.

Here is an example output of this command:

DEBUG INFO:
Number of gouroutines: 17
Instances information:
Hash: INTERNAL_DEV_TEST_SWARM_0747-1
ID: 46bbb227-4d63-11e6-8718-022d0fae0f03
Interface vptp1, HW Addr: 06:05:bb:2b:a6:42, IP: 10.10.1.1
Peers:
	--- 4742e997-4d63-11e6-8e39-022d0fae0f03 ---
		HWAddr: 06:84:e6:ce:48:76
		IP: 10.10.1.245
		Endpoint: 52.28.78.136:53384
		Peer Address: 158.181.222.46:39400
		Proxy ID: 52
	--- End of 4742e997-4d63-11e6-8e39-022d0fae0f03 ---

There is a list of connected peers under "Peers" section.

• IP is an internal IP address
• Endpoint is an IP address used to communicate with this peer. If Endpoint equals Peer Address - that means peers are connected directly in LAN or over Internet. If it's not, that means that traffic forwarder are in use
• Peer Address is the real Internet address of this peer
• Proxy ID contains an ID of a tunnel created on a forwarder