A crazy midi controller make with Seeed Studio's XIAO RP2040 and showting chicken!
- XIAO RP2040 x 1
- Mic board x 1
- Vibration sensor x 1
- 2.54mm pitch lowprofile pinheader (1x7) x 2
- 0805 10kΩ resistor x 1
- 2.54mm pitch L-angle pinsocket (1x4) x 1
- showting chicken (Important! the showting checken must 40cm or larger! it maybe cannot insert to smaller it.) example (must chose '40cm')
- Read the mic board instructions (japanese) and set the mic gain on the mic board to 20db. Solder to the jumper part of the board.
- Solder the parts while looking at the schematic. For thinness, please use low profile pin headers to connect the board and XIAO RP2040.
- Connect the USB cable to XIAO RP2040.
- Insert the board with soldered components through the mouth of the chicken. It's hard to insert, but do your best!
- Use Arduino. First, have the Arduino IDE installed on your PC.
- Next, install the software for XIAO RP2040 on Arduino by Seeed Studio's instructions (Seeed Studio XIAO RP2040 with Arduino).
- Finally, download XIAO-RP2040-CHICKEN.ino and flash it from your Arduino IDE to your XIAO RP2040.
- done! Let's Enjoy with connect through USB your PC and start your MIDI software.
MIT