You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Reset to defaults button in the web UI, below the log button, with a
confirmation dialog. It returns settings to their defaults but keeps the
hotspot settings, so the device stays reachable on its own access point.
Wi-Fi station settings are also kept unless you tick the checkbox in the
dialog. Holding GPIO0 for 5 seconds still wipes everything, hotspot included.
Heartbeat on the onboard LED (GPIO 13), for boards like the Adafruit
HUZZAH32 whose only built-in LED is on that pin.
Normal: alternates bright and dim at 1 Hz, never fully off.
Fault: blinks fully off at 5 Hz. This means a Wi-Fi station is configured
but not connected. Running in hotspot-only mode is not a fault.
Changed
Status LED defaults: hotspot red, Wi-Fi station blue, NTRIP client
green. Before this, the hotspot and NTRIP client defaulted to off and showed
nothing. Brightness is unchanged.
Upgrade notes
The reset button is part of the web files image (www.bin). If you update
only the app over OTA, the button won't appear; flash www.bin too. The POST /config/reset endpoint works with just the app update.
The new colors only apply where no color has been saved. A board that has
saved its settings keeps its old colors. Holding GPIO0 for 5 seconds clears
them and applies the new defaults.
GPIO 13 is now always used for the heartbeat LED, on every board. It can no
longer be used for JTAG (MTCK) or anything else.