Skip to content

v0.6.3

Choose a tag to compare

@benreu benreu released this 20 Oct 15:21
· 9 commits to master since this release

New

  • F9P receiver panel. A new card at the bottom of the web page writes one of two configs to the ZED-F9P over the UART: dual-GPS moving base, or RS-232 NMEA output. It also reads back the current mode, UART2 baud and message rates, and can check every key in RAM and flash against what a write would set.
    • In RS-232 mode you pick the GGA/VTG/RMC/GSA rates (up to 10/5/2/1 Hz) and the UART2 baud (19200 or 38400) on the panel.
    • Corrections to the receiver pause while the ESP32 talks to it: about 6–10 s for a write, 0.35 s for a read, 7 s for a check.
    • New endpoints: POST /f9p/config, GET /f9p/config, POST /f9p/check.
  • Distance to the base station and RTK accuracy. The base position is read from RTCM 1005/1006 in the correction stream. The NTRIP client card shows the 3D, horizontal and vertical distance to the base in ft/mi, plus the base ID and correction age.
    • The same data is in /status under rtk (in metres) and in a $PESP,NTRIP,CLI,BASE,... sentence sent every 5 s.
    • On a VRS mountpoint, the distance is to the virtual station, not a physical CORS.
  • Receiver status on the UART card. Fix, satellites, HDOP, VDOP (from GSA) and 1-sigma lat/lon/alt (from GST) are now shown on the UART card, and they work with the NTRIP client off.
  • Mountpoint picker. A Scan button on the NTRIP client card fetches the caster's sourcetable. Mountpoints are grouped as open or login required, show format, fee and distance, and are sorted nearest first when there is a fix. It works before you save settings.

Fixes

  • The NTRIP and socket clients now reconnect right away when the server closes the connection. Before, the read loop spun on EOF. The NTRIP client ignored the caster for 15–30 s, and the socket client never reconnected if the UART was quiet.
  • The NTRIP client now clears its caster-ready flag on disconnect, so it stops taking GGA while disconnected.
  • Sourcetable replies with HTTP/1.0 200 OK are now accepted.

Build / internal

  • dependencies.lock is now committed, pinning espressif/mdns to 1.11.3.
  • CONFIG_MDNS_ENABLE_BROWSE=y is set in sdkconfig.
  • The web server buffer goes from 2048 to 4096 bytes and the URI handler limit from 10 to 12. index.html now declares UTF-8.
  • tools/f9p/ holds the u-center dumps. tools/f9p_config_gen.py generates main/f9p_config_data.h from them, and --check reports when the header is out of date.

Upgrade notes

Important

Flash www.bin as well as the app. The page changes are in the www SPIFFS image, so an app-only OTA keeps the old page. The /status fields and the $PESP sentence still work without it.

  • The F9P panel needs UBX input turned on for UART1 on the receiver. If it's off, set CFG-UART1INPROT-UBX once in u-center. Reading and checking also need the F9P's TX wired to the ESP32's RX.
  • Sigma and VDOP only show if the receiver outputs GST and GSA on the port wired to the ESP32.

Full Changelog: v0.6.2...v0.6.3