Skip to content

Satellite Network Update on June 3, 2026

Blockstream Satellite edited this page Jun 2, 2026 · 1 revision

On June 3rd, 2026, at 15:00 UTC, the Ku-band signal transmitted over the Galaxy 18 (G18) satellite will move to a new frequency. Hence, users in North America covered by this signal will need to upgrade the CLI/GUI and reconfigure or restart the receiver to continue with reception.

Users covered by the other signals do not need to take any action.

The new Galaxy 18 downlink center frequency will be 12035.1 MHz. It will remain horizontally polarized.

The required software upgrade is already available. However, if you are covered by Galaxy 18, please apply the upgrade only around the scheduled update time: June 3rd, 2026, at 15:00 UTC.

To download the upgraded CLI and GUI versions, run the following:

sudo pip3 install blocksat-cli blocksat-gui --upgrade

Next, verify that the CLI and/or GUI have the new version by running the following:

blocksat-cli --version
blocksat-gui --version

The result should be blocksat-cli 2.5.2 and blocksat-gui 2.5.2, respectively.

Next, if you are running the receiver via the CLI, stop it and restart by re-running the CLI command. The frequency update should apply automatically and log the following to the console:

INFO     Updating the G18 DL frequency from 11913.4 MHz to 12035.1 MHz

If you are running the receiver using the GUI, close the GUI and restart it after the software upgrade. Next, on the Receiver > Settings page, confirm the updated downlink frequency (12035.1 MHz). Then, restart the receiver.

Clone this wiki locally