Repository navigation
Bootloaders arduino variometer
Arduino variometer project including its bootloader.
| Type | Monolithic bootloader (type3) |
| Upstream | https://github.com/prunkdump/arduino-variometer |
| CVEs attributed | 0 |
| Vulnerability-fixing commits | 0 naming a CVE, 0 keyword-matched |
| CVEs with a linked fix | 0 |
Application firmware with a small bootloader for a flight instrument.
Type 3: reset to application on AVR.
See Boot-Stages for the eight-stage model these phases map onto.
- bootloader -- A stock AVR bootloader (Optiboot or similar) occupies the boot section and provides serial programming.
- application start -- The variometer firmware starts and initialises its sensors -- barometer, accelerometer, magnetometer, GPS.
- calibration data load -- Calibration values are read from EEPROM, where the separate calibration sketches in this repository wrote them.
- main loop -- Runs the flight instrument: sensor fusion, display and audio output, logging.
This project is application firmware with a conventional AVR bootloader beneath it, and the only state crossing that boundary is EEPROM: calibration written by one sketch is read by another. It is included in the corpus as a worked example of the Type 3 pattern at its simplest -- reset goes to a small serial-programmable loader, which goes to an application that owns the device -- rather than for the bootloader being novel.
The jump to the application is the AVR bootloader's rjmp to address 0, with nothing passed. There is no verification anywhere in the path.
None detected. That means no matching pattern was found in its build configuration or source, not that the project is insecure -- a small MCU bootloader may simply have nothing to configure.
git -C oss-bootloaders submodule update --init type3/arduino-variometer
./scripts/analysis/run-tool.sh codeql arduino-variometerSee Tools for what each tool applies to.