Repository navigation
Bootloaders firmware
Meshtastic device firmware.
| Type | Monolithic bootloader (type3) |
| Upstream | https://github.com/meshtastic/firmware |
| CVEs attributed | 0 |
| Vulnerability-fixing commits | 0 naming a CVE, 23 keyword-matched |
| CVEs with a linked fix | 0 |
ESP32 and nRF52 firmware for LoRa mesh radios, including its update path.
Type 3: device firmware that owns the MCU from reset.
See Boot-Stages for the eight-stage model these phases map onto.
- SoC ROM / second-stage loader -- On ESP32 the mask ROM loads the second-stage bootloader from flash; on nRF52 an existing bootloader (Adafruit's or Nordic's) occupies that role.
- partition selection -- The bootloader reads the partition table and the OTA data partition to decide which application slot to run.
- verification -- Where secure boot and flash encryption are enabled, the application image's signature is checked and its flash is decrypted.
- application start -- The Meshtastic firmware starts: radio, display, GPS, and the mesh stack.
- OTA update -- New images are received over the network or USB, written to the inactive slot, and marked for the next boot.
The boot-time interface is the ESP-IDF one: a partition table in flash, an otadata partition holding the active-slot pointer and rollback state, and NVS for configuration the application persists. The application marks a new image valid after it has run successfully, and the bootloader reverts to the previous slot if that never happens -- the same confirm-or-rollback contract MCUboot uses, expressed in Espressif's format.
The bootloader jumps to the selected application image with nothing passed beyond what the partition table and otadata already determined. This entry is device firmware rather than a general bootloader, and it is in the corpus because its A/B update path and its network-facing update surface are the parts that matter for bootloader security.
None detected. That means no matching pattern was found in its build configuration or source, not that the project is insecure -- a small MCU bootloader may simply have nothing to configure.
git -C oss-bootloaders submodule update --init type3/firmware
./scripts/analysis/run-tool.sh codeql firmwareSee Tools for what each tool applies to.