20231216

Notes:

• With this update, the sensor will not automatically pause when SD card error detected. If SD card is accidentally ejected, it will wait until SD card is inserted, then resume recording. A line will be added in the CSV file indicating SD card error.

How to upgrade the firmware:

• Connect the sensor to a computer via USB
• With the sensor powered on, double tap the RESET button on the side. (If the sensor is enclosed in the case, you can use an M2 allen-key through the provided hole on the side of the case). This will bring up the "NRF52BOOT" sensor folder.
• Drag and drop the compiled binary ("firmware_xxxx.uf2") file into this new folder. The sensor will automatically disconnect and update the firmware.
• Reconnect the sensor and configure via the dock program.

20221205_0105

Notes:

• Fixed bug with night mode, where after successive dark readings (at night) the sensor would stay in autoexposure mode, and not use the custom exposure check.

How to upgrade the firmware:

• Connect the sensor to a computer via USB
• With the sensor powered on, double tap the RESET button on the side. (If the sensor is enclosed in the case, you can use an M2 allen-key through the provided hole on the side of the case). This will bring up the "NRF52BOOT" sensor folder.
• Drag and drop the compiled binary ("firmware_xxxx.uf2") file into this new folder. The sensor will automatically disconnect and update the firmware.
• Reconnect the sensor and configure via the dock program.

20221013_1331

Notes:

• Changed the wake check frequency to 5000 ms from 1000 ms. This should improve battery life, but may be slightly slower to connect to dock.py'

How to upgrade the firmware:

• Connect the sensor to a computer via USB
• With the sensor powered on, double tap the RESET button on the side. (If the sensor is enclosed in the case, you can use an M2 allen-key through the provided hole on the side of the case). This will bring up the "NRF52BOOT" sensor folder.
• Drag and drop the compiled binary ("firmware_xxxx.uf2") file into this new folder. The sensor will automatically disconnect and update the firmware.
• Disconnect and reconnect the sensor.

20221013_1316

How to upgrade the firmware:

• Connect the sensor to a computer via USB
• With the sensor powered on, double tap the RESET button on the side. (If the sensor is enclosed in the case, you can use an M2 allen-key through the provided hole on the side of the case). This will bring up the "NRF52BOOT" sensor folder.
• Drag and drop the compiled binary ("firmware_xxxx.uf2") file into this new folder. The sensor will automatically disconnect and update the firmware.
• Disconnect and reconnect the sensor.