Skip to content

Releases

Release v3.11.3-Clarijs.5

Choose a tag to compare

@Clarijs Clarijs released this 12 Nov 20:58
f5cfc25

Home battery: peak-shaving SoC

Batteries that do peak shaving keep the lowest part (e.g. below 15 %) for peak shaving only.
New setting Peak Shaving SoC: below that SoC a discharging home battery counts as grid
import in Smart mode, so the EV cannot empty the part kept for peak shaving. Above it nothing
changes; 0 = off.

  • Send the battery power with its state of charge: Set/HomeBatteryPower = W:SoC (e.g. -1250:48)
  • Set it via All settings → Home battery → Peak shaving below, Home Assistant number
    Home Battery Peak Shaving SoC, MQTT Set/HomeBatteryPeakShavingSoC or REST
    home_battery_peak_shaving_soc

Why: after a battery calibration the home battery (35 %) fed the EV at ~2.5 kW down to 12 %,
below the 15 % it keeps for peak shaving.

Also

  • CAP STOP (Max Sum Mains Time) is now on the LCD for every capacity mode (also Peak, Flanders
    and Interval), and on All settings → Capacity. Without a home battery set it to 0 or 1 minute.
  • The home battery fields on All settings are aligned.

All settings are kept. Full list: CHANGELOG · Install: unzip the -dist.zip and
upload firmware.bin at http://smartevse-<serial>.local/update.

Release v3.11.3-Clarijs.4

Choose a tag to compare

@Clarijs Clarijs released this 11 Nov 08:09
04535f1

New web interface

The start page is now a visual dashboard: charging status, a capacity bar (room left under your
monthly peak), the home battery, a 10-minute chart and big mode buttons. Every setting is under
All settings. All pages share the same style, with light and dark mode.
Screenshots: see the README.

Changes

  • Removed Battery Guard (not needed with mode Peak, the measured voltage and a battery
    peak-shaving threshold just under the monthly peak).
  • Home battery: send only the power in W (Set/HomeBatteryPower); state of charge and
    Full SoC are removed. A payload with :SoC still works.
  • Sensorbox 2 on the P1 port: the meter voltage is used by the capacity modes (not tested
    on real hardware).

All settings are kept. After updating, delete the old Home Assistant entities
Battery Guard … and Home Battery Full SoC.

Full list: CHANGELOG · Install: unzip the -dist.zip and upload firmware.bin
at http://smartevse-<serial>.local/update.