Skip to content

Releases

Kalamar 0.3.5

Choose a tag to compare

@CyriacFR CyriacFR released this 15 Nov 21:27

Kalamar 0.3.5

Fixed

  • Native mouse aiming: the camera looked up by itself when you left squid form. Since 0.3.3 a move up made in squid form, or just as you came out of the ink, turned the view several times too far once you were back in human form (3 degrees of mouse left the view 8 degrees too high, 12 degrees 31 too high). The view now ends where your moves put it, within about half a degree.
  • Native mouse aiming: at the start of a battle, on the result screens and after a very fast vertical flick, the view could jump by 15 to 30 degrees. It now stays where it is.
  • What changes for you: in squid form, above level, the view turns about 3.4 times less than your move, as with the game's own aiming. Human form is unchanged.
  • Your game must be rebuilt once: Kalamar says "Game update available" and does it when you click. Your save, profile and settings are kept.

Known limits

  • Not tried with native mouse aiming: respawning, super jumps, charged specials, scoped weapons, ink rails. If the camera still moves by itself, close the game, send us the launcher's diagnostic right away (it holds the end of the game's log) and say what you were doing.
  • If a single frame takes longer than a quarter of a second, the mouse moves made during it are dropped.

Updating

  • From 0.2.0 or later: Kalamar offers this version by itself.
  • From 0.1.0: download it by hand, once, and replace your Kalamar.exe.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.3.4

Choose a tag to compare

@CyriacFR CyriacFR released this 15 Nov 19:10

Kalamar 0.3.4

Fixed

  • Matches that did not start ("The game could not play this match", teams-not-set, or "the host left the room" for the other players): on a PC that showed fewer than about 40 frames a second in the lobby, the host's game pressed on the team screen before the game had opened it, and the teams were never confirmed. The game now waits for each screen before it presses. Checked in 1 v 1 matches on one PC; tell us if a match still fails to start, with the diagnostic.
  • Your game must be rebuilt once: Kalamar says "Game update available" and does it when you click. Your save, profile and settings are kept.

New

  • Friends: a "Blocked players" list with an Unblock button. Unblocking does not make you friends again: send a new request.
  • Upscaler: AMD FSR 4.1 and FSR 3.1 can be chosen (thanks to coffeecode3d). They need AMD's FidelityFX files beside the game, which Kalamar does not ship; without them the game keeps FSR 1. This path was not tested on Windows with those files: treat it as experimental and tell us what you see.

Known limits

  • When you change form while moving the mouse with the aim high up, the view can settle about half a degree lower each time.

Updating

  • From 0.2.0 or later: Kalamar offers this version by itself.
  • From 0.1.0: download it by hand, once, and replace your Kalamar.exe.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.3.3

Choose a tag to compare

@CyriacFR CyriacFR released this 15 Nov 17:05

Kalamar 0.3.3

Fixed

  • Native mouse aiming, since 0.3.2: after pushing the aim against its upper or lower limit, or after changes between squid and human form, one axis could stop answering until a setting was touched, and the view could jump at a change of form. Both are fixed; the "vertical limit" setting no longer bounds the aim.
  • Input delay, one frame less: the game used to work out each picture before it read your mouse, keys and controller, so a move was shown one picture late. It now reads them first. Measured at 60 fps with the mouse: about 16 ms less between your move and the picture. Buttons and sticks take the same path but were not measured.
  • Your game must be rebuilt once more: Kalamar says "Game update available" and does it when you click. Your save, profile and settings are kept.
  • If the picture stutters or something looks a frame off after this update, add the line "input_first = 0" to kalamar.ini, and tell us.

New

  • Main abilities: the Locker lets you choose the main ability of your headgear, clothing and shoes, beside the three sub abilities. The choices are the abilities a real piece of that part can have; presets keep them. Your game must be rebuilt (see above) before the choice is applied.
  • The install accepts an .xci cartridge image for the base game, beside .nsp (thanks to coffeecode3d). The update is still an .nsp.

Known limits

  • When you change form while moving the mouse with the aim high up, the view can settle about half a degree lower each time.
  • The .xci support was checked with the launcher's tests and by its author on Linux; tell us if your file is refused.

Updating

  • From 0.2.0 or later: Kalamar offers this version by itself.
  • From 0.1.0: download it by hand, once, and replace your Kalamar.exe.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.3.2

Choose a tag to compare

@CyriacFR CyriacFR released this 15 Nov 12:16

Kalamar 0.3.2

New

  • Native mouse aiming: the mouse now turns the aim directly. The game used to smooth it like a controller's gyro: looking up or down took more than 9 frames to arrive, and turning back was eased. Both axes now answer at once, and a mouse move turns the aim by the same angle up and down as left and right, wherever you look. The setting is "Native mouse aiming" in the mouse settings (mouse_native in kalamar.ini); a controller and its gyro are not affected.
  • Loadout presets: the Locker can save your weapon and gear under a name, and apply, rename or delete it later.

Fixed

  • Input delay, again: the game read the mouse, the keys and the controller a whole frame before it showed the picture. It now reads them just before drawing: measured at 60 fps, 12 ms less between your move and the picture.
  • To get both, your game must be rebuilt once: Kalamar says "Game update available" and does it when you click. This rebuild is longer than the last one. Your save, profile and settings are kept.
  • If the picture stutters after this update, add the line "late_input = 0" to kalamar.ini, and tell us.

Known limits

  • Native mouse aiming was tested in the test range and in matches. Tell us if a weapon, a scope or a special aims oddly: "mouse_native = 0" goes back to the older behaviour.

Updating

  • From 0.2.0 or later: Kalamar offers this version by itself.
  • From 0.1.0: download it by hand, once, and replace your Kalamar.exe.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.3.1

Choose a tag to compare

@CyriacFR CyriacFR released this 14 Nov 21:45

Kalamar 0.3.1

Fixed

  • Input delay: the mouse, the keyboard and the controller felt late in the game. Every finished frame waited two more frames before it was shown. It is now shown at its turn: measured in a match at 60 fps, that wait went from 28 ms to 2 ms.
  • To get the fix your game must be rebuilt once: Kalamar says "Game update available" and does it when you click. Your save, profile and settings are kept.
  • If the picture stutters after this update, add the line "low_latency = 0" to kalamar.ini to go back to the older pacing, and tell us.

The mouse was already read raw, without acceleration or smoothing; that has not changed.

Updating

  • From 0.2.0 or 0.3.0: Kalamar offers this version by itself.
  • From 0.1.0: download it by hand, once, and replace your Kalamar.exe.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.3.0

Choose a tag to compare

@CyriacFR CyriacFR released this 14 Nov 18:36

Kalamar 0.3.0

The game moves to Splatoon 3 11.3.0

  • Kalamar now builds version 11.3.0 of the game. If your game was built from 11.2.0, the Play page says "Game update needed": give it your 11.3.0 update file and it builds the new version next to the old one, keeps your save, profile and settings, and deletes the old game only once the new one works. You need about 13 GB free while both exist.
  • Until you update, you can still play 11.2.0 offline. Online play needs 11.3.0: both versions cannot play together.

New

  • Sub-abilities: in the Locker, Gear tab, choose the three sub-abilities of each piece you wear. A piece with sub-abilities shows with 2 stars in the game. A server room set to "main abilities only" ignores them.
  • Full stock of ability chunks: a new option in the Locker's launch options.
  • Updates are shown everywhere: a bar on every page says when a new Kalamar or a game update is waiting, and Kalamar asks once when it starts. It now checks at every start and every 6 hours. Nothing is downloaded until you click.

Fixed

  • When a match was found while your game was already open, the match failed after a long wait. Kalamar now closes the open game and starts the match, and tells you so beforehand.
  • When your game files are damaged, the install wizard now says which one (the base game or the update) instead of a vague merge error.
  • Dialogs no longer let the page behind show through their text.

Updating

  • From 0.2.0: Kalamar offers this version by itself (Settings, About).
  • From 0.1.0: download it by hand, once, and replace your Kalamar.exe.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.2.0

Choose a tag to compare

@CyriacFR CyriacFR released this 14 Nov 15:59

Kalamar 0.2.0

Fixed

  • The install wizard no longer stops at the "keys" step with "zstd.exe is needed": it failed on every PC without developer tools. If your install stopped there, start this version and run the wizard again; it picks up where it left off.
  • The wizard no longer fails on a game file whose name has characters outside your Windows language (Japanese names on a Western Windows, for example).

New

  • Kalamar now updates itself. From this version on, new versions are offered in the launcher (Settings, About) and are installed only if they are signed by the maintainers.
  • You can save a copy of your data from a community server and erase your account there: Community, the server's Account tab, "Your data".
  • English is the default language; French, Spanish and Japanese are still there and follow your Windows language.

If you have 0.1.0

  • 0.1.0 cannot update itself: download this version by hand, once, and replace your Kalamar.exe. Your game and settings are kept.

Kalamar is an unofficial fan project. It contains nothing of the game: you need your own copy.

Kalamar 0.1.0

Choose a tag to compare

@CyriacFR CyriacFR released this 14 Nov 14:13

Kalamar 0.1.0

First public build of the Kalamar launcher for Windows 10 and 11 (64-bit).

What it does

  • Builds a native Windows version of the game on your PC, from your own copy of the game. Nothing of the game is
    included or downloaded.
  • Starts the game, keeps its settings, and updates the build when the engine changes.
  • Plays online on community servers that speak the open Kalamar protocol: add a server by its address in Community.
  • Interface in English, French, Spanish and Japanese.

How to use it

  1. Download Kalamar.exe, put it in a folder of its own, and start it.
  2. Follow the install wizard. The first build takes a long time and needs free disk space; the wizard says how much.
  3. Guides: docs/getting-started.md and docs/servers.md in the repository.

Good to know

  • Windows may show a SmartScreen warning: the program is not signed with a commercial certificate. Check the file
    against SHA256SUMS before starting it.
  • This build does not update itself: later versions are downloaded here by hand.
  • No support is given to obtain the game, its update, keys or firmware.
  • Kalamar is an unofficial fan project, not affiliated with or endorsed by any game publisher.

Checksum (SHA-256) of Kalamar.exe: see SHA256SUMS.