Skip to content

Aether Term 1.1.5

Choose a tag to compare

@github-actions github-actions released this 14 Oct 00:36
b11731a

Fixed

  • The radio can no longer be left keyed by PTT commands running out of
    order.
    Each VARA HF PTT ON / PTT OFF was handed to its own
    background thread. When keying the rig was slow (OmniRig, CAT), a
    PTT OFF could run before the PTT ON ahead of it and leave the
    transmitter keyed until the 90-second watchdog fired. Keying now runs on
    one worker thread, in the order VARA asked, and the watchdog's forced
    release queues behind it. (vara/ptt.py)

  • PTT is released whenever the modem link closes. If VARA crashed or
    its TCP link dropped mid-transmission, the radio stayed keyed until the
    watchdog fired. A call that failed with WRONG or CANCELPENDING also
    left the rig link open. Now any end of the modem link unkeys the radio
    and closes the rig link at once. (gui/main_window.py)

  • Via boxes show the whole callsign. In 1.1.4 the Via 1 / Via 2
    dropdowns had only a maximum width, and the toolbar squeezed them to about
    35 px: "None" read "one" and only two letters of a callsign were visible.
    They now always have room for a full call with SSID (WD5EMA-15).
    (gui/main_window.py)

Added

  • VARA HF sends P2P SESSION. VARA's command reference says
    P2P SESSION "must be used for P2P connections, not for Gateways", and
    VARA HF defaults to WINLINK SESSION, a 4-second retry cycle meant for
    Winlink gateways. Calls to a BBS or station now use P2P. A new
    Settings → Session Type option switches to Winlink gateway for RMS
    calls. VARA FM, Aether HF and Soundmodem are unchanged.
    (config.py, vara/modem.py, gui/settings_dialog.py)
  • Digipeaters with Soundmodem (AGWPE). Via 1 / Via 2 now work in
    Soundmodem mode. The call goes out as AGWPE's "connect via" frame (v:
    the digipeater count, then each call), so the path is set per call from
    Aether Term. Soundmodem's own Digi settings are for Soundmodem acting as
    a digipeater, and do not route outgoing calls. VARA HF and Aether HF still
    refuse a Via path. (vara/agwpe.py, vara/agwpe_modem.py, gui/main_window.py)
  • VARA HF end-to-end tests. A full session against the fake modem
    covers the init commands, CONNECTED … 2300, PTT keying and unkeying
    through a fake rig, release on disconnect, a refused call, a rejected
    CONNECT, and a modem crash while keyed. The PTT controller has its own
    tests for ordering, the watchdog and stop. Both modem drivers now ignore
    initialization arguments they don't use, so a new argument can't crash
    one of them again. (tests/test_vara_hf.py, vara/modem.py,
    vara/agwpe_modem.py)