Skip to content

ecat ecat-v0.22

Pre-release
Pre-release

Choose a tag to compare

@github-actions github-actions released this 17 Nov 09:13
· 41 commits to main since this release

ecat for LinuxCNC 2.9 and 2.10: from this release the same ecat is built for both series. LinuxCNC 2.9 (2.9.4 or newer, Debian's or linuxcnc.org's packages) gets a package; 2.10, which has no Debian packages yet, gets the run-in-place archive and a package as before.

Install

First the userspace master, linuxcnc-ethercat-uspace 1.5 from MetalMusings/ethercat (unchanged since 0.21): sudo apt install ./linuxcnc-ethercat-uspace_*_amd64.deb. Then the file for your LinuxCNC:

  • LinuxCNC 2.9 (2.9.4 or newer, as packages): linuxcnc-ecat_*+lcnc2.9.debian13_amd64.deb (or .debian12). It replaces ecat 0.11.
  • LinuxCNC 2.10 run-in-place: unpack ecat-rip-0.22-debian13.tar.gz (or -debian12) and run ./install. ecat.so is built against LinuxCNC commit b0e7b191b9 (2.10.0~pre2-436); the installer refuses if your tree's HAL headers differ and says how to build from source.
  • LinuxCNC 2.10 package: linuxcnc-ecat_*.deb without +lcnc2.9.

The window, ecatsetup --gui, needs python3-pyqt5. To try ecat without disturbing your setup: getting started. See the README.

What is new in 0.22

LinuxCNC 2.9. Everything up to 0.21 (tuning, feedforward, EoE, serial channels, unused slaves, the DC reference clock, From lcec, the window) now works on 2.9 too. The component is written against 2.10's HAL API; on 2.9 one header gives that API on 2.9's pins, so there is no separate 2.9 code. Where the series differ:

  • Integer pins have 32 bits on 2.9 (64 on 2.10). Commands are held within the PDO entry's range anyway, so entries up to 32 bits behave the same.
  • LINT/ULINT entries and the encoder's 64-bit count are float pins on 2.9 (exact up to 2^53). ecatsetup --check refuses hal-type: sint/uint on a LINT/ULINT entry on 2.9 and proposes real; extend is for 8- and 16-bit entries only.
  • The same ethercat.yaml works on both.
  • EtherCAT Setup finds the series by itself (HAL types, INI keys such as HOME_SEARCH_DIST only on 2.10, component names, LinuxCNC's pins).

ecat 0.11.x is closed. 2.9 users move to this package; 0.11 gets no more fixes.

Fixed: the 2.10 package lacked the shipped SYNC0 measurements (ecatsetup/measured/) since 0.20; the run-in-place archive had them.

Tried on 2.9.4: ecatsetup --check and the I/O test in the window on a plasma cutter's bus (three ECT60 drives and an I/O board): all slaves in OP, DC phased, two cycles from output to status, the drives without fault. Not tried on 2.9 yet: LinuxCNC itself with motion (next), 2.9.5 to 2.9.10 (same HAL API), Debian 12.