Repository navigation
Bed Tramming
The bed mesh corrects small hills in the bed. Tramming makes the four corners the same height first, so the mesh has less to correct. The printer measures the corners and tells you exactly what to do, one corner at a time.
Start it from Calibration → 1 Bed Tramming on the screen, or run the
NEBULAOS_BED_TRAM macro in Mainsail. The bed must be empty. The printer
homes and probes the four corners.
- Rigid spacers. This is the stock KE: no knobs under the bed. You correct a low corner by adding a thin printed shim under it.
- Rubber or springs. A common upgrade. You correct a corner by turning its screw.
The answer is remembered for next time.
- The printer measures all four corners (3 samples each).
- A corner within 0.10 mm is OK and is never selected again.
- You get one instruction for the worst corner, for example:
- "Rear right: add a 0.10 mm shim. Unscrew this corner's bed screw, put the printed shim on the spacer, and screw it back firmly. Do not touch the other corners."
- "Rear right: turn the screw a quarter of a turn clockwise."
- Tap Done - measure again. Repeat until "Bed tramming complete".
Front is the side with the screen. The bed screws are M4x25.
Print a few thin washers that fit around the M4 bed screw (hole about 4.5 mm). Two each of 0.10, 0.20 and 0.30 mm cover most beds. The wizard rounds its advice down to whole 0.10 mm steps, so it never asks for too much.
- A corner did not improve after 2 adjustments. Check that the screw and spacer at that corner are tight, and that nothing is bent or loose (bed, gantry).
- A corner that was OK moved after another adjustment. Check that every bed screw is tight, then start again.
- If the front-left corner was shimmed or changed, the printer offers a load cell calibration. That corner carries the load cell. See Load cell calibration.
- Otherwise it offers Z offset & bed mesh. Do that next.
Get started
Get great prints
- Calibration guide (4 steps)
- Calibration walkthrough (A→Z)
- Bed tramming
- Load cell calibration (water bottle)
- Axis Twist Compensation
- Adaptive meshing + purge
- Square parts (Skew Correction)
- Quieter steppers (TMC Autotune)
Using the screen
Help
- Working on NebulaScreen
- Build from source
- Dev & simulator
- Architecture
- Configuration
- Releases & deployment
- Testing
- CI
- Contributing
- Publishing this wiki
NebulaOS