Repository navigation
tabby-v04.11.2
Full backup works on songs with a scene stored on the panel; otherwise tabby-v04.11 (clip chains). Use this page instead of tabby-v04.10, tabby-v04.11 and tabby-v04.11.1.
Classic Tabby tabby-v04.11.2: the page reads what the panel stores
- Firmware package build ID:
5132d1244cb66781(first 16 hex digits). App image 479236 bytes (measured), margin 40221 bytes
below the 519457-byte limit. The firmware's code is tabby-v04.11's; only the page changed. - Installing over tabby-v04.2 to tabby-v04.10 keeps storage as it is. Take a Full backup first, with this page.
- Going back to older firmware: songs saved on tabby-v04.10 or later cannot be read by older firmware. Go back to
an older build only with a Full backup made before tabby-v04.10: install the older build, then restore that backup.
Fixed
- Full backup, verify and restore stopped on a song with a scene stored on the panel (hold an empty pad on SCENES,
new in tabby-v04.10): the status line said "Scene n is invalid" and the backup stood still at about 66 %. The page has
two readers for a song record and both refused the mark such a scene carries. tabby-v04.11.1 corrected one of them and
was published before the second was found; its backup still stopped. This build corrects both, and the corrected page
was run against the test device before it was published: the backup of the device that the other pages could not
read went through (30 blocks). - The firmware was not at fault and nothing on the device was lost. tabby-v04.11 and tabby-v04.11.1 were never
installed, because the backup that must come first did not finish. - The page keeps a song's click and count-in settings when it reads and writes the song.
What tabby-v04.11 brought
- Clip chains on CLIP SETTING: NEXT CLIP (STAY, STOP or a clip), AFTER (the clip's end, or 1 to 512 steps), TIMES.
- The count-in ends exactly on the beat.
Validation on the device (2026-11-16, unattended)
Full backup through this page (the device held a song with a panel-stored scene: 30 blocks), one install attempt:
"Firmware ready." after 9.4 s. Clip chains 11 of 11 (clip 2 starts 0.03 ms from the cycle line; the first run's "5.8 ms
late" was the test tool's own clock arithmetic). CLIP SETTING, click and count-in 21 of 21: MIDI Start 1999.47 ms after
the first click of the count-in (one cycle is 1999.1 ms); the internal click recorded every 500 ms. Recording 25 of 25,
STEP page 18 of 18, CLIPS page 40 of 40 twice. 960 notes on one line: 2.04 ms band on DIN, 2.02 ms on USB (clock ratio
0.999556 in this run; 0.999600 and 1.89 / 1.80 ms on tabby-v04.10 an hour earlier). Backup and verify after: PASS.