Repository navigation
Solar Power Tower
The Solar Power Tower is a large multiblock structure that concentrates reflected sunlight to produce Molten Salt or Steam at scale. It is the high-throughput successor to the Solar Heater and rewards a well-built field of Solar Mirror around it.
Right-click the tower with a Create Wrench to switch between Molten Salt mode and Steam mode. Switching clears whatever fluid is currently stored, so you cannot accumulate both at once - pick one output and commit to it.
- Molten Salt mode: converts piped-in water into Molten Salt, for use with a Heat Battery and Create boiler
- Steam mode: produces Steam directly from sunlight with no water input at all, ready to pipe straight into a Steam Turbine. This makes the tower a self-contained solar-to-power chain without needing a Heat Battery or boiler.
Place Solar Power Tower blocks in a square footprint (1×1, 2×2, or 3×3) and stack them vertically. Use the Solar Power Tower item while looking at the side of an existing tower block to auto-fill an entire vertical column in one click, the same way fluid tanks and the Fermentation Vat work.
| Footprint | Max height |
|---|---|
| 1×1 | 5 blocks |
| 2×2 | 10 blocks |
| 3×3 | 20 blocks |
Minimum size: the tower requires at least a 3×3 footprint and 3 blocks of height to produce anything. Smaller towers are structurally valid but inactive.


- Clear sky above the top block of the tower
- Daytime (before 12,000 ticks)
- No rain or thunderstorm
- Water supply piped into any face (Molten Salt mode only - Steam mode needs no water)
- A field of linked Solar Mirror nearby for anything beyond baseline output
Solar Mirror are freestanding - place them on the ground anywhere within the tower's search radius, not against its walls. A mirror links automatically if it has open sky above it and a clear line of sight to the tower; once linked, it continuously tracks the sun and reflects it toward the tower.
The tower scans for mirrors every 2 seconds. The search radius is a circle centered on the tower:
radius = min(4 + height × 2, 24)
| Height | Search radius |
|---|---|
| 5 | 14 blocks |
| 10+ | 24 blocks (hard cap) |
A tower will never track more than 128 mirrors at once, regardless of size (configurable).
Mirror efficiency follows a triangle curve:
- 0 mirrors → 0% efficiency
- Optimal count → 100% efficiency
- 2× optimal → 0% efficiency (over-mirroring shuts production down)
| Footprint | Search radius | Optimal mirrors |
|---|---|---|
| 1×1 (h=5) | 14 blocks | 75 |
| 2×2 (h=10) | 24 blocks | 128 |
| 3×3 (h=20) | 24 blocks | 128 |
Optimal mirror count scales linearly with how close the tower's search radius is to the 24-block cap, up to the 128-mirror tracking limit. Any tower with height 10+ already sits at the radius cap, so 2×2 and 3×3 towers share the same optimal count - and since 128 is also the hard tracking limit, over-mirroring isn't actually reachable at that size.
Both modes scale off the same base rate, which depends on footprint area and tower height:
baseRate = width² × (height / maxHeight)^1.5 × mirrorEfficiency
Each mode applies its own multiplier on top of that base rate:
-
Molten Salt mode:
baseRate × 0.4 -
Steam mode:
baseRate × 7/3
At full size and 100% mirror efficiency:
| Footprint | Height | Salt out | Water in (salt mode) | Steam out |
|---|---|---|---|---|
| 3×3 | 20 | 3.6 mB/tick | 32.4 mB/tick | 21 mB/tick |
| 2×2 | 10 | 1.6 mB/tick | 6.4 mB/tick | 9.3 mB/tick |
| 1×1 | 5 | 0.4 mB/tick | 0.4 mB/tick | 2.3 mB/tick |
Water consumption in Salt mode scales with width² - a 3×3 tower uses 9 mB of water per mB of salt produced. Plan your water infrastructure accordingly. Steam mode consumes no water at all.
A max-size 3×3 tower in Steam mode produces enough Steam to run one fully built Steam Turbine at full efficiency; in Molten Salt mode it produces enough Molten Salt to keep 9 Heat Batteries (one per base block) superheated continuously.
In Molten Salt mode, water fills in through any face and Molten Salt drains from any face. In Steam mode, only Steam drains - there's no water input to worry about. Both tanks scale with total block count (8,000 mB per block).
The tower's side displays a water gauge (needle driven by water tank fill level). The block texture changes between inactive, active (sun only), and active-with-mirrors states.
- Right-click (no sneak) with a Create wrench to toggle between Molten Salt mode and Steam mode. This clears whatever fluid is currently stored.
- Sneak + right-click to break the tower and collect all blocks.
Create: Solarpunk
Solar Panels
Electricity
Solar Heat
Steam
Biofuel
- Biomass
- Biomass Gasifier
- Fermentation Vat
- Bioreactor
- Hemp
- Biofuel Engine
- Biochar
- Kinetic Sprinkler
- Greenhouse
Geothermal
Endgame
Global Warming
Building
More