Repository navigation
OpenRDX v1.07
OpenRDX v1.07
OpenRDX 1.07 makes the installed firmware version visible to host tools and
updates receiver discovery to support both versioned and legacy OpenRDX builds.
It retains support for RDX cartridges and qualifying, unlocked standard SATA
drives in the supported Tandberg Data RDX QuikStor external USB 3.0 dock.
This release is experimental. Hardware validation and drive compatibility
remain limited.
Changes
- Accurate firmware identification: SCSI INQUIRY reports
0107and the USB
device revision reports0107h, corresponding to OpenRDX1.07. Earlier
builds used the fixed SCSI marker0001and USB revision0283h. - Updater compatibility: the guarded Windows updater recognizes OpenRDX
revisions0107,0106, and legacy0001. It checks that the reported disk
revision and Windows PnP identity agree before selecting a receiver. - Updated installation instructions: the matching guide covers first
installation from vendor firmware and updates of existing OpenRDX receivers.
Download and install
Download OpenRDX-v1-07.zip
and extract it into its own directory. Keep the six installation files together:
the .bin container, FlashBurner .hex image, .json manifest, .sha256
checksum list, Windows updater, and OPENRDX_USB_UPDATE.md.
Verify every file listed in OpenRDX-v1-07.sha256, then follow the included
installation guide. SHA256SUMS
also covers the downloadable assets, including the archives.
Installation requires Windows, elevated PowerShell, stable USB power, an empty
bay, and careful receiver selection.
| Installed receiver firmware | Procedure |
|---|---|
Vendor 0283 |
First installation, using -InstallOpenRDXOnCompatibilityReceiver and TI Command Line FlashBurner |
OpenRDX 0107, 0106, or legacy 0001 with the required OPENRDX1 update protocol |
Update existing OpenRDX, using -InstallOpenRDX with the matching .bin and .json files |
Use the complete installation guide
for commands and completion checks, and keep the
ROM-loader recovery guide
available. Do not substitute -Update for -InstallOpenRDX; -Update selects
restoration of the pinned vendor firmware.
Supported hardware and limitations
This release targets the Tandberg Data RDX QuikStor external USB 3.0
compatibility receiver built around TI TUSB9261, identified before first
installation by vendor revision 0283. Support for other docks, bridge chips,
or receiver revisions is not established.
The version-reporting and updater changes have not been qualified on physical
hardware for this release. A reported revision does not verify the installed
image hash, and discovery alone cannot establish that a legacy build supports
the required update protocol.
Standard SATA compatibility, full RDX Manager functionality, cold starts,
large-capacity I/O, and repeated eject/reinsert operation still need broader
hardware testing. See the firmware behavior and validation limits.
Source and licensing
Source for v1.07.
Created by André Fiedler / SunboX. Repository-owned software is offered under
AGPL-3.0-or-later; identified documentation uses CC-BY-SA-4.0. TI material
and third-party documents retain their separate notices and terms. See
LICENSE,
NOTICE, and
commercial licensing information.