Skip to content

v0.1.0: browser control (not tested on hardware yet)

Pre-release
Pre-release

Choose a tag to compare

@github-actions github-actions released this 26 Oct 15:22
· 20 commits to webcontrol since this release

ESP-Drone with browser control, v0.1.0. Not tested on real hardware yet:
remove the propellers and work through the bench checklist in
docs/e1-mini.md before the first flight.

Install

In the browser: https://technikweber.github.io/esp-drone/ (Chrome or Edge on a computer,
one click). Other ways, including Espressif's own tools:
docs/flashing.md.

Each file is a complete image for address 0x0:

File Board Chip
espdrone-e1-mini-esp32.bin E1 Mini ("ESP32 Drone" kit) ESP32
espdrone-s2-drone-esp32s2.bin Espressif ESP32-S2-Drone ESP32-S2
espdrone-s2-drone-esp32s3.bin Espressif ESP32-S2-Drone with ESP32-S3 ESP32-S3
esptool.py --chip esp32 --port /dev/ttyUSB0 --baud 921600 write_flash 0x0 espdrone-e1-mini-esp32.bin

Back up the factory firmware first if you want to go back (read_flash 0 ALL, see the guide).

What's in it

  • Browser control over the drone's Wi-Fi with a captive portal: WebSocket, only the newest
    command counts, late commands are dropped, staged failsafe (hold, level out, descend, off).
  • Battery protection: forced landing below 3.0 V, no arming below 3.4 V.
  • Roll and pitch trim, stored on the drone. Control page in English and German.
  • Board support for the E1 Mini (ESP32 DevKit, MPU6500 on SPI, 8520 motors) with controller
    gains from the vendor firmware.
  • Based on espressif/esp-drone master@9d5a4f8, built with ESP-IDF 5.5.

SHA-256

6d19bc2907a321c33b4a71e4146482afa870061fb636736a15e970af3b382799  espdrone-e1-mini-esp32.bin
43b4520a0d0716f2bdfa2553bc82f29d220e797203bb58678c6a584255af4082  espdrone-s2-drone-esp32s2.bin
7773a3f58bd20ff62048a0c4dcd331a0a689875004ead2a9c83ad779e20256d5  espdrone-s2-drone-esp32s3.bin