Skip to content

ground-v1.6.0

Pre-release
Pre-release

Choose a tag to compare

@ThePrivatePanda ThePrivatePanda released this 16 Nov 18:56

Test build with new flight software. Seen on a board on the bench: boot-air transmitting at the air gap, take-off on movement in about a second, landing after 30 s still, and a 6 ms gap between back-to-back packets. The landed duty cycle and Stop2 have only been tested on a computer, so try it on a spare board first. It is marked as a pre-release, so the app won't offer it as an update.

New in 1.6.0

  • Flight software: boot-air transmits at the air gap. A board lands after 30 s still at any height, or 60 s still whatever the altitude says. A missing IMU reading counts as no movement.
  • Flight software: once landed with a good fix, the board parks. It wakes once per ground rate, tries the GPS for up to 10 s (60 s every 10th wake), sends one packet and sleeps in Stop2. Tilting it or a climb wakes it fully.
  • Flight software: a 2048-byte console buffer, so printing no longer holds up the loop.
  • ChipSats page: one ground rate for transmitting and logging. 0 is allowed with a warning.
  • ChipSats page: console log level and carrier frequency (902.0-928.0 MHz) per board, checked against the board's start line after a write.
  • ChipSats page: a console card for every board, with a filter over the whole session.
  • T-Beams: carrier frequency per T-Beam. ChipSat consoles and T-Beams are now told apart without asking.
  • Analysis tab: one phase bar over the boots you pick, sensor strips, first IMU and GPS times, a table of everything in a pull, and charts of every field.
  • Live and Replay: a 3D view and a map of a flight.
  • Receiver programs: the app can run a program as a receiver (receiver = in descent-ground.conf).