Repository navigation
CPCSyntaxError v0.13.1
CPCSyntaxError v0.13.1
This release adds the serial link of the Albireo 1.1 board. It also adds the last CH376 command that was not emulated.
Albireo 1.1: the serial link
The Albireo 1.0 and 1.1 boards have a UART (an SC16C650B) with a USB serial link to another computer. The Albireo 2.0 has no UART.
To fit it, tick Serial link (Albireo 1.1) under Albireo 1 in Expansions.
-
The UART is at
&FEB0-&FEB7. It has 32-byte FIFOs, automatic RTS/CTS and Xon/Xoff flow control, and a loopback mode. Its clock is 24 MHz, so the line can run at 1.5 Mbaud. -
The far end can be:
- nothing
- a port on your PC that another program connects to
- a connection to host:port
- a serial port of your PC
- a loopback plug
For a PC program that opens a COM port, use a virtual serial port pair (for example com0com).
-
Interrupts: the UART sends its interrupt to the CPC's INT when MCR bit 2 is 0, and to NMI when MCR bit 3 is 0. These sources can also cause an interrupt:
- the CRTC CURSOR signal
- the CH376
- the DTR line of the far end
-
DIP switches:
- S1 lets the CH376 interrupt through.
- S2 resets the CH376 with the CPC.
- S3 lets the far end reset the CPC.
- S4 makes the DTR line of the far end an interrupt.
-
On the command line:
--albireo-serial <line>(tcp:host:port,listen:port,com:COM3,loopbackor-) and--albireo-switches 1100(S1 to S4).
The test program of the Albireo manual (16c650.bas) runs. With a loopback plug, it gets back all the bytes it sends.
CH376: DISK_BOC_CMD
The CH376 now does command 50H. This command sends a SCSI command to a USB stick: INQUIRY, READ CAPACITY, TEST UNIT READY, REQUEST SENSE, MODE SENSE, START STOP and READ/WRITE (10) with no blocks. As on the real chip, it gives an error on the SD card.
Build
- The macOS package is built again when a version is tagged. GitHub stopped the
macos-14build machine, and the automatic build of v0.13.0 failed. The v0.13.0 packages came from a later build of the same source.