Skip to content

CPCSyntaxError v0.14.1

Choose a tag to compare

@WacKEDmaN WacKEDmaN released this 07 Nov 17:23
· 7 commits to main since this release

CPCSyntaxError v0.14.1

This release lets a classic CPC load cartridges, adds an Expansion port window to the debugger, and corrects the CM14 monitor on the 6128 Plus.

Cartridges on a classic CPC

  • Load a CPR on a 464, 664 or 6128 and the machine stays as it is: the same model, CRTC and expansions. The emulator no longer changes to a Plus or a GX4000.
  • The cartridge is mapped as on a Plus: page 0 is the lower ROM, and &DFxx selects the other pages. On a real CPC, an M4 Board loads cartridges the same way.
  • Most cartridges run. A cartridge that unlocks the Plus ASIC (for example Sonic) needs a Plus or a GX4000.
  • With no machine chosen, or on a Plus, a cartridge loads as before.

Expansion port window

Debug → Expansion port shows the CPC's 50-way expansion connector.

  • The pins: each pin has a lamp that lights while its signal is active and then fades, so a short pulse such as /NMI or /RESET can be seen. The address and data pins show the last I/O cycle. The tooltip on a pin tells what it does, how much of the last second it was active, and how often it switched on.
  • Boards on the bus: each fitted board, the ports it decodes, its reads and writes each second, and its last access. A board that decodes only some address bits is shown as a bit pattern.
  • Port clashes: the ports that two fitted boards both answer, for example the SSA-1 and the Kempston mouse at &FBEE. A real bus has the same clash.
  • I/O log: the last 256 I/O cycles with the PC, the port, the value and the devices that answered.
  • Stop on access: the CPC stops, as at a breakpoint, on an I/O cycle that reaches a board you choose.
  • The window samples only while it is open.

Fixes

  • Monitor (CM14, 6128 Plus): a second sync about 30 characters after the line sync that runs past the half line now moves the picture slowly to the right, as on a real CM14. The CTM is not changed. SHAKER DH/B2, D3/A6 and D3/B6 on CRTC 3 now match the photographs of a real 6128 Plus.
  • Rewind: the text now says that the Albireo boards, the Albireo serial link and the HD20 are not rewound.
  • Expansions: every expansion was checked. Each board, when you remove it, leaves the machine as it was before it was fitted.