Skip to content

Releases

WeAct Studio DAP Flasher 1.0.0

Choose a tag to compare

@WeActStudio WeActStudio released this 02 Nov 09:49

Programs Cortex-M devices through a CMSIS-DAP probe using the Keil .FLM flash algorithms already installed on your machine - no conversion step, no extra pack download.

Highlights

  • GUI and command line front ends over one probe (USB HID or USB bulk / WinUSB).
  • Identifies the chip behind the probe from its device id register: STM32 (full DEV_ID table), Nordic nRF52, Artery AT32. The table is an editable mcu-ids.txt next to the executable, re-read on every identify.
  • Detects a hardware reset that never reaches the target (no nRESET wire) and falls back to a software reset with a warning, instead of programming the flash on top of an untouched core.
  • Verifies by reading the flash back through the debug port.
  • Decodes the SW-DP DP IDCODE and shows it next to the target.

Requirements: Windows 10/11 64-bit. Unzip and run - Qt, hidapi and libusb are linked statically, no runtime installation needed.

Note on the SWD clock: 8 MHz or lower is reliable with this probe. 10 MHz fails roughly one run in fifteen with an SWD fault; the tool retries at 8 MHz automatically.


通过 CMSIS-DAP 探针烧录 Cortex-M,直接复用本机 Keil 的 .FLM 下载算法,不需要转换,也不需要另外下载 pack。

主要特性

  • 图形界面 + 命令行双前端,共用同一支探针(USB HID 或 USB bulk / WinUSB)。
  • 从器件 ID 寄存器识别探针那头的芯片:STM32(完整 DEV_ID 表)、Nordic nRF52、Artery AT32。型号表是 exe 旁边的 mcu-ids.txt,每次识别都重读,可随时添加。
  • 能识别「硬件复位没有真正到达目标」(nRESET 没接线),自动改用软件复位并给出提示,而不是在一个没被复位的内核上直接擦写 Flash。
  • 通过调试口回读 Flash 做校验。
  • 解码 SW-DP 的 DP IDCODE,显示在目标旁边。

运行要求:Windows 10/11 64 位。解压即用 —— Qt、hidapi、libusb 全静态链接,无需安装任何运行时。

关于 SWD 时钟:这支探针用 8 MHz 或更低最稳。10 MHz 大约每 15 次会有一次 SWD 故障,工具会自动降到 8 MHz 重试。