Repository navigation
13BMSP obd2
alex-aleyan edited this page Mar 25, 2021
·
1 revision
- https://components101.com/connectors/obd2
- https://learn.sparkfun.com/tutorials/obd-ii-uart-hookup-guide
- https://pinoutguide.com/CarElectronics/car_obd2_pinout.shtml
- https://connector.pinoutguide.com/16_pin_car_j1962_obd_2_special/
- https://pinoutguide.com/CarElectronics/obd-2_universal_cable_pinout.shtml
- mazda: https://pinoutguide.com/CarElectronics/mazda_obd2_diagnostic_pinout.shtml
- https://www.rx8club.com/series-ii-interior-audio-electronics-167/rxduino-development-chat-218257/
- https://www.rx8club.com/series-ii-technical-trouble-shooting-160/any-canbus-gurus-house-217628/
- FORScan:
- CAN
- PIN 4, 5 are grounds
- PIN 6 (CAN-HIGH) and PIN 14 (CAN-LOW) are CAN J-2284
- see CAN ISO 15765-4 and SAE J2284
- ISO 15765 CAN (250kbit/sec or 500kbit/sec)
- pin 6: CAN High
- pin 14: CAN Low
- Used in most modern vehicles.
- PIN 7 is K-LINE Diagnostic (ISO 9141-2 and ISO/DIS 14230-4).
- ISO 9141-2. This protocol has a data rate of 10.4 kbaud, and is similar to RS-232.
- ISO 9141-2 is primarily used in Chrysler, European, and Asian vehicles.
- pin 7: K-line
- pin 15: L-line (optional)
- UART signaling (though not RS-232 voltage levels)
- K-line idles high
- High voltage is Vbatt
- Message length is restricted to 12 bytes, including CRC
- Note that pins 4 (battery ground) and 16 (battery positive) are present in all configurations. Also, ISO 9141 and ISO 14230 use the same pinout, thus you cannot distinguish between the two simply by examining the connector.