Skip to content

v1.0: Shredlight SL-300 mounts for the Radium Mach One S

Latest

Choose a tag to compare

@beadon beadon released this 16 Nov 09:59
· 3 commits to main since this release

3D-printable mounts for Shredlights SL-300 lights on a Radium Mach One S: the light receiver, a clamp for each side of the front truck, and a two-light bar for the rear truck. Every part in this release has been printed and fitted on the board.

Front truck mounts Rear light mount

What to print (attached below)

File Part How it prints
shredlight_mount_left_v7.stl, shredlight_mount_right_v7.stl The receiver the light clips into (v7: slot plus snap-fit barbs). For mounting lights elsewhere. Lip down, no supports.
truck_mount_left_m14_saddle.stl, truck_mount_right_m14_saddle.stl Front truck clamp with a built-in v7 receiver, one per side. Receiver face down.
truck_mount_left_m14_keeper.stl, truck_mount_right_m14_keeper.stl The keeper that closes each front clamp. Flat, nut pocket on the bed, no supports.
rear_mount_r5.stl Rear light mount: two v7 receivers on a bar, on a shoe that locks into the oval hole in the rear truck's hanger pocket. Receiver faces down, shoe and plug pointing up, no supports.

Every STL is exported in its print orientation; slice without rotating. The slicer profile used (Prusa MK4 Input Shaper, 0.4 mm nozzle, organic supports tuned to break away cleanly) is in PRINT_SETTINGS.md.

Hardware

  • Front, per side: one M4×20 socket-head screw and one M4 nyloc nut, fitted through the receiver's slot with the light removed.
  • Rear: one M4×16 socket-head screw and one plain M4 hex nut (3 mm thick), slid into the shoe's side slot. Use a drop of removable threadlocker.

Fitting

  • Front: the saddle hangs on the hanger's strut, the keeper hooks in under it, and the screw pulls them together round the strut (0.25 mm clearance, no liner).
  • Rear: back the angled screw off until its end is inside the plug, drop the plug into the oval hole, and tighten the screw from the nose side until it's snug. Its steel shank goes under the lip at the hole's rear end. The charging plug still fits between the lights.

Notes

  • Designed and fit-tested for the SL-300 only.
  • The truck shapes in the renders are schematic; only the parts the mounts touch are measured.
  • The engraved *_art saddle variants aren't included: the artwork isn't GPL.
  • Each part's version history (v1–v7, m1–m14, r1–r5) is in the README's roadmap.

Licence: GPL-3.0. Shredlights, Radium and Mach One are trademarks of their owners; this project isn't affiliated with or endorsed by them.