Prusa Remote Display 1.0.0

Prusa Remote Display 1.0.0

Your print, at a glance. A small local-network display built and tested for the
Prusa CORE One with PrusaLink, using the Waveshare ESP32-S3-LCD-2.8 non-touch
board and a printed enclosure.

• Follow printing progress, pause, completion and printer errors without opening
  your phone. The display can sleep after a completed print.
• Set up Wi-Fi and PrusaLink locally. Your Wi-Fi password and printer key belong
  on the display's setup page; they are never entered on the installation site.
• Install ready-made firmware from desktop Chrome or Edge with a USB data cable.
  Initial installation erases saved display settings and does not change the printer.
• Firmware updates are offered for confirmation; the display does not install an
  update without your choice. Routine monitoring stays on your local network.

Build and setup guide
· Browser installer
· Installation and recovery
· Source archive

Use only the supported non-touch board. The touch model and other ESP32-S3
boards are not supported. PrusaLink compatibility details and local-network
requirements are in the setup guide. Safari can read the guide but cannot install
firmware over USB.

Code and tools are GPL-3.0-only with the ESP-IDF additional permission in
LICENSING.md; enclosure hardware is CERN-OHL-S-2.0; documentation is CC-BY-4.0.
Upstream dependencies keep their own terms and notices. Independent community
project; not affiliated with or endorsed by Prusa Research.