Skip to content

Releases

floppy3.5 v1.0.0

Choose a tag to compare

@bigcrimping bigcrimping released this 15 Nov 12:04

First release of the floppy3.5 firmware: the RP2354A controller and the ESP32-S3 bridge.

What's in the zip

Folder File Use
controller-rp2354/ gw_rp2354.uf2 Install through USB: hold BOOTSEL (S4), connect power, copy the file to the RP2350 drive
controller-rp2354/ gw_rp2354.bin Update through WiFi from the web page
bridge-esp32s3/ flash_args + 4 .bin files First install through USB with esptool.py
bridge-esp32s3/ gw_wifi_bridge.bin Update through WiFi: Rear panel ▸ SHOW ▸ FIRMWARE UPDATE

SHA-256 checksums are in SHA256SUMS.txt.

First install of the bridge

Run these from inside bridge-esp32s3/:

esptool.py --chip esp32s3 -p <PORT> erase_flash
esptool.py --chip esp32s3 -p <PORT> write_flash @flash_args

Do the first install with the board on USB power. The firmware sets the charger limits at each start, and until it runs the board does not work fully on battery.

Supported disks

  • 1.44 MB HD disks with a FAT12 file system (for example Sony Mavica disks).
  • Only the files in the root folder are shown and copied. Folders and hidden files are skipped.
  • 720 KB DD and other formats are not supported.

Known issues

  • The bring-up self-test (firmware/esp32-bringup/) is not in this release. It does not build against the current LCD display settings yet.
  • The controller uses the default Raspberry Pi USB ID (2E8A:000A), so give the gw tool the port: gw read --device <PORT> ...

Build info

Controller and bridge built from commit 976c3ce (ESP-IDF 5.2.7, pico-sdk 2.x). Tested on the gen-4 board: both chips updated over WiFi, then a full disk read with no bad sectors.