Repository navigation
Manufacturer Documentation
Paul edited this page Dec 18, 2017
·
2 revisions
These are some useful sections from the original TCP Connected Gateway documentation. Complete original documents are available below
The following illustration shows the different ports, buttons, and indicators on the Gateway. You can use it as a reference during installation or while following the instructions or performing tasks.

- Sync button: Button that syncs devices and shows current activity and status of synced devices.
- WAN (Internet connection) error indicator: Indicator that shows whether or not the Gateway is connected to the Internet.
- LAN (home network) error indicator: Indicator that shows whether or not the Gateway is connected to your network.
- Power indicator: Indicator that shows whether or not the Gateway is powered.
- Network socket (RJ45): Ethernet port to connect the Gateway to your network.
- Power adapter socket: Socket to plug in the Gateway power adapter.
This will help reset bulbs that were previously paired to another gateway or a exclusively to a remote
- Take the lamps to reset and insert them into a socket (preferably one that is controlled by a switch).
- You will begin with the lights turned OFF
- Power cycle the lights 3 times by turning them on/off, on/off, on/off - after three, turn them on for a fourth time and leave them on - after several seconds, the bulbs should start pulsing, which means they are ready to be paired.
- Install each network light bulb into the light fixtures as you would any standard light bulb.
- Turn power on to the light fixtures.
- The light bulbs will brighten and dim while attempting to connect wirelessly to your Gateway.
- Press the sync button on the Gateway once to enable the connection. The activity indicator begins to display a clockwise rotating pattern.
- When the light bulbs are connected to your Gateway, they turn on to full brightness. Press the sync button on the Gateway again to stop the network search process (otherwise the Gateway will stop the search process automatically in five minutes after finding the most recent light bulb).

-
Additional Project Information