Repository navigation
omapass 0.1.48
Added
- New
auto-syncsetting (defaultoff): whenon, OmaPass runs a sync
right after every insert, edit or delete, instead of only onCtrl+S. Off
by default because it adds a network round trip — and its possible failure
— to every single edit. (#46)
Fixed
-
Ctrl+S (sync) no longer leaves the entry list stale once the pull/push
finishes.syncwas fired through the same detached helper used for
clipboard/type actions, so nothing ever reloaded the list or surfaced a
failure when it was done; it is now a tracked process like every other
write, and reloads the list (or reports the error) on exit. (#45) -
syncno longer reports success when git failed.pass(1)ends inexit 0
and its git handler never checks the git it just ran, sopass git push || diecould not fire however badly the push went — an unreachable remote, a
rejected update and a store with no remote at all all printed "Store synced"
and exited 0, with2>/dev/nulldiscarding the only remaining evidence.syncnow runs git directly in the store, which is the same invocation
pass gitmakes minus the discarded status, and each call is guarded. A
store with no remote configured says so and names the command that adds one,
rather than failing as though the network were at fault. The wording of each
failure stays ours: git's own stderr names the file it tripped over, and an
entry name is disclosure in its own right. ([#49])This is the only place it bit —
pass show,mv,rmandotpall fail
through pass's owndie, which exits 1 before that finalexit 0is
reached, so their guards work. ([#49])
Install
omarchy plugin add https://github.com/cschaba/omapass.git --enable --yesOr from the tarball below:
tar -xzf omapass-0.1.48.tar.gz
cd omapass-0.1.48 && ./install.shsha256: d5bdfe2f08e9c98dc2f752b5d199791a63bc14829b2f09db35e4446edd5abea3
Under development and largely untested — see the warning at the top
of the README before trusting it with anything.