Skip to content

Releases

v1.1.2-cj1 (NerdQAxe+)

Pre-release

Choose a tag to compare

@cyberjunky cyberjunky released this 17 Nov 12:27

Build for the NerdQAxe+, based on shufps v1.1.2 with six fixes. Built from branch fix/quiet-pause-and-robustness.

Fixes

  • Quiet fans while paused: when mining is paused with /api/system/shutdown (e.g. by a home automation following surplus solar), the fans used to keep running at the manual speed (default 100%) or at least 15%.
    • They now idle under temperature control with a 0% floor, so they stop when the board is cool.
    • Board temperatures are still read, so the fans spin up again if needed.
    • Normal fan settings return on restart.
  • Fan 2 PWM frequency: both fan channels now run at 19.53 kHz. Fan 2 was at 4.88 kHz, which is audible.
  • Ping lock-up: the ping task held its lock through delays and pings, which could stall the web UI and display for seconds.
  • Stratum input checks:
    • Malformed pool messages (wrong mining.notify params, extreme difficulty or extranonce sizes, out-of-range job ids) are rejected instead of crashing.
    • Requests to the pool are serialized.
  • Data races:
    • Settings and fan reloads, swarm fan updates, board error flags, pool host strings, hashrate monitor start-up, InfluxDB counters and CAN TX mutex creation are now properly locked.
    • The swarm fan PATCH also range-checks its fields.
  • OTA failure handling:
    • A failed firmware upload now aborts and restarts cleanly.
    • Upload timeouts are capped.
    • The web UI partition is erased in chunks.

Install

  • Update an existing miner:

    1. In AxeOS, turn on the hidden Danger Zone toggle: the faint ⚠ button at the bottom of Settings.
    2. Under Legacy Update, upload esp-miner-NerdQAxe+.bin.
    3. Then upload www.bin.

    This keeps your Wi-Fi, pool and board settings.

  • esp-miner-factory*.bin: a full flash image for a fresh install or recovery over USB, flashed at offset 0x0. Expect to set up the miner again.

  • Going back: use AxeOS → Update to install an official shufps release again.

Tested

On a NerdQAxe+:

  • It boots and mines, and the settings were kept after the update.

Fan behaviour during a long pause still needs to be confirmed in practice.