Repository navigation
BX Tacho 2.2.0
BX Tacho firmware 2.2.0, for the Beyblade X launcher RPM meter. Web app: https://dazchi.github.io/bx-tacho/
What's new
- Steadier VBAT calibration: while
cal vbat pointorcal vbat verifymeasures (about 0.5 s), the display is frozen: no redraws and no traffic to it, so the board's current, and with it the voltage being measured, stays steady. Calibration mode already keeps the RPM channel and the load LED off and the chip out of light sleep. Bluetooth keeps running, as it carries the console; calibrating over a data-only USB connection withble offremoves its radio bursts too.
Everything else is as in 2.1.0.
Updating
From 2.0.0 or 2.1.0: your settings and calibration are kept.
From 1.x: calibrate again as described in the 2.0.0 release (the layout changed in 2.0.0).
Known limitation: after switching on, or moving BX Tacho from a black launcher to a white one, it stays on the black settings until the first top is loaded (or the pin pushed up). Until then the empty white launcher shows LOADED.
Files
| File | For |
|---|---|
bx-tacho-v2.2.0.bin |
Updates. In the web app: USB tab (computer, or Chrome on Android with a USB-C cable) or Bluetooth tab. Settings, shot history and calibration are kept. |
bx-tacho-v2.2.0-merged.bin |
A blank board: everything from address 0x0. Overwrites settings and shot history; the battery calibration is kept. |
ota_data_initial.bin |
A blank otadata (8 KB of 0xFF), only for flashing bx-tacho-v2.2.0.bin by hand (below). |
SHA256SUMS.txt |
Checksums of all three. |
Release build, optimised for speed (-O2), ESP-IDF v6.1.
Updating from a firmware before 0.8 (single app slot): update over USB once. That writes the two-slot partition table that Bluetooth updates need. After that, Bluetooth updates work too.
Flashing by hand (esptool):
python -m esptool --chip esp32c3 write-flash 0x10000 bx-tacho-v2.2.0.bin 0x10e000 ota_data_initial.bin
python -m esptool --chip esp32c3 write-flash 0x0 bx-tacho-v2.2.0-merged.bin
The first form writes the app and a blank otadata, so the board boots this app rather than one in the other slot; the web app does that for you. The second is for a blank board.
Licensed under the GPL, version 3 or later (see NOTICE for the additional permission covering extensions).