Repository navigation
BX Tacho 2.3.0
BX Tacho firmware 2.3.0, for the Beyblade X launcher RPM meter. Web app: https://dazchi.github.io/bx-tacho/
What's new
- No false switch to the white launcher: pushing a bey in too far on a black launcher lifts the pin high for a moment, which read like a loaded white launcher and switched BX Tacho to the white settings. Switching to white now needs readings above the white launcher's loaded threshold for 3 seconds without a break; a pushed pin drops back long before that. On a white launcher, BX Tacho now switches about 3 seconds after the first bey is loaded, and the launch arms normally then. Switching back to black is unchanged.
cfg autowhite on|off: turns the automatic white launcher detection off (on by default). Off, BX Tacho always uses the black launcher's settings, for anyone who only uses dark launchers. Saved at once and kept bycfg reset;statusnotes when it's off.- New defaults (used after
cfg resetor on a new board): RPM threshold 80 mV on black and 90 mV on white, and a white launcher loaded level of 750 mV. Saved calibrations aren't changed. - Web app: both consoles (USB and Bluetooth) stay scrolled to their latest output.
Updating
From 2.0.0 or later: your settings and calibration are kept.
From 1.x: calibrate again as described in the 2.0.0 release (the layout changed in 2.0.0).
Known limitation: after switching on, or moving BX Tacho from a black launcher to a white one, it stays on the black settings until a bey has been loaded (or the pin pushed up) for 3 seconds. Until then the empty white launcher shows LOADED.
Files
| File | For |
|---|---|
bx-tacho-v2.3.0.bin |
Updates. In the web app: USB tab (computer, or Chrome on Android with a USB-C cable) or Bluetooth tab. Settings, shot history and calibration are kept. |
bx-tacho-v2.3.0-merged.bin |
A blank board: everything from address 0x0. Overwrites settings and shot history; the battery calibration is kept. |
ota_data_initial.bin |
A blank otadata (8 KB of 0xFF), only for flashing bx-tacho-v2.3.0.bin by hand (below). |
SHA256SUMS.txt |
Checksums of all three. |
Release build, optimised for speed (-O2), ESP-IDF v6.1.
Updating from a firmware before 0.8 (single app slot): update over USB once. That writes the two-slot partition table that Bluetooth updates need. After that, Bluetooth updates work too.
Flashing by hand (esptool):
python -m esptool --chip esp32c3 write-flash 0x10000 bx-tacho-v2.3.0.bin 0x10e000 ota_data_initial.bin
python -m esptool --chip esp32c3 write-flash 0x0 bx-tacho-v2.3.0-merged.bin
The first form writes the app and a blank otadata, so the board boots this app rather than one in the other slot; the web app does that for you. The second is for a blank board.
Licensed under the GPL, version 3 or later (see NOTICE for the additional permission covering extensions).