Repository navigation
MHO900 test build 10: mho-acq-1, the first acquisition (development build)
Pre-releaseDevelopment build for testing on an MHO900. Not a release. This is mho-acq-1, the first build that tries to
measure: it starts the acquisition board from your unit's own snapshot of the stock system and acquires the
probe compensation signal. Not yet verified on hardware.
What you need first: a snapshot taken with mho-check.py version 9 (mho-dev-9)
under the stock system, python3 mho-check.py <scope-ip> --snapshot.
Then, with this build installed (as mho-dev-7: ADB route or card route) and the probe compensation signal still on
the channel the snapshot named:
scp mho-snapshot-*.txt root@<scope>:/oos/mho-snapshot.txt
ssh root@<scope> oos-mho-liveoos-mho-live runs oos-fpgad mho-start and writes its report to /oos/mho-start.txt. The run does the bring-up,
sets the ADCs, the JESD204 receiver, the FPGA and the front end from the snapshot, reads it all back, and arms one
acquisition. Its last line is RESULT: IT MEASURES ... when the square wave came back. It then restarts the screen on
the board's frames instead of the demo signal. oos-mho-live off goes back to the demo; a power-off undoes all of
it. oos-fpgad mho-start --dry lists every step without touching the board.
Only the snapshot's setting is measured (one channel, its scale, 200 us/div). The keys still act on the demo's terms.
Please post /oos/mho-start.txt (scp root@<scope>:/oos/mho-start.txt .) and, if the screen shows something, a photo.
| File | What |
|---|---|
oos-mho900-dev-10.img |
the OOS image, for the install on a second card (boot/card-install.py, then boot/switch.py oos) |
oos-mho900-dev-10.oosupd |
the same image as a signed package, for the install over ADB (oos-update gel-install) |
oos-update |
the install tool of this build, for the scope (aarch64) |
MHO900_OOS_Install.GEL |
the stick install. Not known whether the stock MHO900 update accepts it. Use the ADB or card route |
SHA256SUMS |
checksums |
Changes since mho-dev-7: oos-fpgad mho-start, oos-mho-live, oos-ui's live source for the MHO900, the front ends'
select lines named in the device tree, the register window mapped up to 0x40000. The decision is ADR 0075 (proposed).
Built from tag mho-dev-10 with kernel/build-base.sh and OOS_BOARD=mho boot/build-dev-image.sh, Linux 6.12.115. Sources: this tag, and the third-party sources of v0.1.14. The instructions are in the issues: #4, #248 and #491.