Repository navigation
LineageOS 24 (alpha) · 2026-11-20 (latest)
LineageOS 24 (Android 17) on mainline Linux 7.3.1 for the ZTE Axon 7 (A2017G): an alpha / developer preview, flashable in TWRP into the LineageOS slot of the multi-boot setup. Not for daily use: no calls, no mobile data, no camera, no suspend.
Alpha. Back up first. Make a TWRP backup (Boot, EFS, Modem, and anything else you want to keep) and copy it to a computer before installing. Any failure while flashing can brick the phone.
Requirements (read first)
- A2017G only (tested on 4 GB / 64 GB).
- Unlocked bootloader, TWRP 3.3.0-0 (
twrp-3.3.0-0-ailsa_ii.imgfrom https://dl.twrp.me/ailsa_ii/; the tested version). - The project's multi-boot setup (boot menu with iOS / Nura / LineageOS), including the partition step
axon7-tripleboot-gpt, which creates the LineageOS partitions: DEV-MULTIBOOT.md. This build does not install on its own. - The vendor partition of a ROM installed before (LineageOS 16–18.1, or this project's LineageOS 22.2) must still be in place: the GPU firmware is read from it. Do not wipe Vendor in TWRP.
What the zip changes
- Writes
super.imginto the GPT partitionsystemand the kernel intolos_boot. - Erases
los_metadataandlos_data: all LineageOS data in the multi-boot slot is lost, and a LineageOS 22.2 installed in that slot is replaced. - Does not touch
boot,misc, iOS, Nura,persist, the modem/EFS partitions or the bootloader.
No proprietary firmware is in the zip. LineageOS 24 loads the modem, DSP, GPU and Wi-Fi board firmware straight from the phone's own partitions, read-only, at every start (modem, and a530_zap from vendor). This is new in this release and still being tested.
Install
- TWRP 3.3.0-0: back up (see above) and copy the backup to a computer.
sha256sum -cthe zip against the.sha256file.- Copy the zip to the phone and install it in TWRP; it must finish without an error.
- Reboot and choose LineageOS in the boot menu. The first start takes a few minutes.
State
Tested on the phone: boots to the setup wizard and home screen; display 1440x2560 with brightness slider; touchscreen and the three touch keys; Wi-Fi scans and connects; Bluetooth turns on; speaker playback and microphone recording; accelerometer, gyroscope, magnetometer, light and proximity sensors; battery level and charging; temperature sensors; hardware watchdog; plain reboot returns to LineageOS; modem firmware boots and goes online, GNSS service starts; software codecs (Codec2). A 20-minute stress soak ran without crashes, reboots or kernel warnings.
Built, not tested yet: headphone playback (jack detection is wired up), vibrator, GPS fix.
Not working: calls, SMS, mobile data (no radio HAL yet; SIM not detected so far), camera, fingerprint (TrustZone-owned), NFC, suspend/deep sleep (short battery life), encryption.
Scrolling is usable but not perfectly smooth (about 13 % janky frames in a scroll benchmark).
Userdebug build, SELinux permissive (policy in progress). Graphics: Mesa freedreno (Adreno 530, GLES 3.1), drm_hwcomposer, minigbm.
Problems
Enable USB debugging (Settings → About phone → tap Build number 7 times; System → Developer options) and send adb logcat -b all -d and adb shell dmesg. After a crash or restart, go to TWRP right away (Power + Volume Up about 10 s) and send adb pull /sys/fs/pstore/. Say which build (date) you run.
Source
Kernel (GPLv2): Linux 7.3.1 with the Axon 7 patches at https://github.com/devilAPI/linux/tree/zte-axon7, plus the Android kernel patches, Mesa patches and device tree on the lineageos-24-mainline branch of https://github.com/devilAPI/zte-axon7 (folder lineageos-24-mainline/).
Not affiliated with ZTE or LineageOS. Flash at your own risk.
This is a copy of LineageOS 24 (alpha) · 2026-11-20 (lineageos-24-20261120), the newest published build.