Repository navigation
BenchPod Desktop 0.1.3
The rest of the pod's controls, beside the agent.
New
- SPI flash chip (Flash tab, below the firmware flasher): identify a 25-series SPI NOR flash on the wiring's SPI pins, erase, write and verify an image (optionally holding your board in reset), and read it back as hex or to a file.
- This pod (Settings): the pod's board, firmware, connection and network at a glance; Wi-Fi (show, scan, join, forget); network access on Ethernet and Wi-Fi (open, locked or off) and HTTPS-only; the USB network adapter on or off; the firmware signature policy; and deregistering the pod from embeddedci.com when you are signed in (not in offline mode). The Wi-Fi password is never written to the action log.
- Calibration (Settings): what the pod has stored, the ADC offset, each DAC output's line from two readings of your multimeter, the ADC gains, and going back to the built-in values (a second click confirms it).
These ask before they change the pod, like every other control, and go to the action log.
Install instructions: https://github.com/embeddedci-com/benchpod-desktop#install
SHA256SUMS lists a checksum for every file here: sha256sum -c SHA256SUMS --ignore-missing.