Skip to content

Version 2.0.0

Choose a tag to compare

@UncleRus UncleRus released this 12 Nov 23:05
· 10 commits to main since this release
7651307

The component now drives both the SGP40 and the SGP41 through a single API.
The SGP41 is the same sensor with an added NOx channel, and it requires the
conditioning command before the first measurement: sgp4x_start_conditioning()
runs it and returns the raw VOC value for every cycle, so the sensor can be
watched while it warms up. After that, sgp4x_measure_index() returns the VOC
index and, on the SGP41, the NOx index, both computed by Sensirion's Gas Index
Algorithm, which replaces the older VOC algorithm.

The new sgp41 example shows the whole sequence: the humidity and the
temperature are taken from an AHT sensor during the conditioning, the sensor
warms up for ten seconds and the loop then prints both indices with the air
quality verdict. The header of the vendor algorithm is documented on the
component page as well.

Breaking changes

  • sgp40.h is now sgp4x.h, and the prefix of every function, type and
    constant is sgp4x_: sgp40_t became sgp4x_t, SGP40_ADDR became
    SGP4X_ADDR.
  • sgp4x_init_desc() takes the device type, so a single call describes either
    chip: sgp4x_init_desc(&dev, SGP4x_TYPE_SGP40, port, sda, scl).
  • sgp40_measure_raw() became sgp4x_measure_raw(), which fills the raw VOC
    value and, on the SGP41, the raw NOx value.
  • sgp40_measure_voc() became sgp4x_measure_index().
  • sgp40_soft_reset() is gone: the initialization reads the serial number and
    the featureset, and the datasheet's reset command is no longer needed.

Thanks to @botastic for the SGP41 support and for the unified driver.

Full changelog: 1.0.8...2.0.0