Repository navigation
Offsets limited to two axes #1057
Closed
MethylBromide
started this conversation in
Ideas
Replies: 1 comment 1 reply
|
@MethylBromide Good point, and it's built now: the Offset panel gets a "Sides only" tick. The sides move by the distance, while every flat top and bottom stays at its height, so a sign or a base gets a border all round without getting taller. On a stepped body each step keeps its own height. It works for grow and shrink, with round or sharp corners, and for the hole copy too. It comes with the next release. |
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
The Offset modifier is MOST EXCELLENT.
The only problem I have with it, is that about 90% of the time I want to do an offset, I want to do it in two axes. So I want to enlarge something in X and Y, say, with a consistent border width all around, but I don't need the Z axis enlarged.
This is easy enough to fix if the shape is flat and I choose sharp outer corners, but difficult to impossible to correct if either of those is not the case.
Sometimes it's reasonable to do this a different way, e.g. by starting with the larger shape and using Hollow. Sometimes, not.
All reactions