Repository navigation
Replies: 1 comment 6 replies
|
@rickmb66 Thanks, good point. The size marks stood a fixed 9 mm away from the edges, which is fine on a normal part but far off screen on one below a millimetre. With the next update they stay close to the part however far you zoom in, so you can read them without zooming out. Until then, the Properties panel on the right shows the Length, Width and Height of the selected part at any zoom, and you can type exact values there too. If you'd like to help keep layerling going, a small donation is always appreciated. |
6 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment

Uh oh!
There was an error while loading. Please reload this page.
I design a lot of parts that are sub-mm in size. Is there a way to get the displayed dimensions closer to the object? I have to zoom out to see the dimensions then zoom back in
All reactions