jayecu v0.3.26

Firmware 0.4.18 (build b32e6af)

• New start sequence (Configuration ▸ Engine Functions ▸ Engine Start). A press of the start button is held
  until the engine is fit to crank: every electronic throttle has passed its key-on check, and the fuel pump
  has brought the rail up — to 250 kPa when a rail pressure sensor is reading (at once if it is still up;
  cranking anyway after 3 s), or for 1 s when there is none. A rail that bled down after the key-on prime
  used to meet the first crank, and the prime pulse, empty. The starter output now cranks on Crank Request
  (crank_req) and the fuel pump also runs on Start Pump (start_pump): run the output wizard on the
  Starter Motor and Fuel Pump outputs to take the new conditions (an output set up before keeps reading the
  button). A tap is enough; holding the button still gives another crank after the rest. New channels
  Start Sequence, Crank Request and Start Pump are in the default logs. A start that had to crank on a low
  rail raises P0087 (level 1, cleared by the next start that reaches pressure) and the console says what
  pressure it got to; a press dropped after the wait says what it was still waiting on.

Studio 0.3.26

• New page: Configuration ▸ Engine Functions ▸ Engine Start, with the start sequence settings and a live readout of what a start press is waiting on.
• The Starter Motor and Fuel Pump output templates use the start sequence (re-run the output wizard on those outputs to take it).

Firmware kits for jaytek_v1 and proteus_f7.