Repository navigation
RF Noise Map 1.2.0 (testing)
Pre-releaseRF Noise Map 1.2.0 (testing)
TESTING VERSION: UNTESTED IN THE FIELD. This is a pre-release for testing on more computers. It has passed its self-test with practice data and on one Windows 11 PC with a real RSP1 and USB GPS, but a real drive has not been done yet. The Mac version has never been tried on a real Mac. Please tell KW4EX what works and what does not (open an issue on this page).
Windows installer: Install_RFNoise_Windows.bat. Mac: RFNoise_Mac_v1.2.0.zip.
Windows is the main version (Windows 10 and 11). A Mac version is included but experimental and not yet tested on a real Mac (see Assets).
Find power-line and other radio noise by driving a route: an SDRplay receiver and a GPS log the signal level about every 10 feet, and the program draws a street map of blue (weak) to red (strong) dots, so you can see where the noise is loudest.
How to download (no GitHub account needed)
Windows
- Install nothing first: the installer finds Python for you and offers to install it (Python 3.9 is used because the radio library needs that version).
- Look at the Assets list at the bottom of this page and click Install_RFNoise_Windows.bat. Your browser saves it, normally in your Downloads folder (if it warns that the file may be harmful, choose Keep).
- Double-click it. If Windows says "Windows protected your PC", click More info then Run anyway. It asks a few short questions and installs into its own
RFNoisesubfolder (suggested:C:\RadioScripts). - At the end, say yes to the full test, with the radio and GPS plugged in.
Mac (experimental)
- In Assets click RFNoise_Mac_v1.2.0.zip. Open Downloads and double-click it to unzip.
- Open the mac folder, right-click Install_RFNoise.command, choose Open, then Open again.
Do not click "Source code (zip)" or "Source code (tar.gz)". Those are for programmers.
The Install and User Guide (PDF) is attached below, and in the repository under docs/guides.
New in 1.2.0
- Installer picks the right Python: the SDRplay radio library for Windows (PothosSDR) only works with Python 3.9; the installer detects this, uses Python 3.9 and installs it if needed. It also repairs pip.
- Find my GPS: finds a USB GPS puck and its speed (4800, 9600, 38400, 115200) by itself, in the window (button), in the installer, or with
Find_GPS.bat. - Full test:
Test_Everything.bat(or the Full test button) checks Python, the radio (real readings and gain control), the GPS, and a pretend drive with the real radio and builds a map, in about a minute. - Radio and GPS busy? Leftover RF Noise Map helpers are closed at launch. Other SDR or GPS programs (SDRuno, SDRconnect, SDR Console, HDSDR, u-center and similar) are listed in a yellow box with a button to close them; nothing is closed without your OK.
- Clearer GPS messages (port in use, wrong speed, no satellites); fixes for the radio library on Windows.
No warranty. Use at your own risk. Shared by one radio operator, "as is". Design and on-air testing by KW4EX. Not made, approved or supported by SDRplay, Elecraft, FlexRadio, Thetis or Zeus.
Testing pre-release: not the final version.